VORTICE TR-ED 400 Degree C or 2h Roof Fan Fume Extraction Instructions

VORTICE TR-ED 400 Degree C or 2h Roof Fan Fume Extraction

Read these instructions carefully before installing and connecting the appliance. Vortice cannot assume any responsibility for damage to property or personal injury resulting from failure to follow the instructions given in this booklet. Following these instructions will ensure long service life and overall electrical and mechanical reliability. Keep this instruction booklet in a safe place.

DESCRIPTION AND OPERATION

The product you have purchased is an industrial centrifugal extractor fan for free radial extraction or extraction into ventilation duct.

WARNING – CAUTION

Warning: this symbol indicates precautions that must be taken to avoid injury

• Do not use this appliance for purposes other than the proper purposes described in this manual.
• After removing the appliance from its packaging, ensure that it is complete and undamaged. If in doubt contact a professionally qualified electrician or Vortice*. Do not leave packaging within the reach of children or the infirm.
• To remove the appliance, turn it off at the switch then disconnect it from the power supply.
•  Store the appliance out of the reach of children and infirm persons if you decide to disconnect it from the power supply and no longer use it.
• Do not use this appliance in potentially explosive or flammable atmospheres or to extract acidic or corrosive fumes.
• Have the appliance internally cleaned by professionally qualified personnel only.
• If installing the appliance at a height less than 2.5 metres above the floor, an additional protective grille over moving parts must be fitted (fig. 6).
• When installing appliances type TRT 50 ED 4P, TRM 70 ED 4P, TRT 70 ED 4P, TRT 70 ED 6P, TRT 100 ED 4P, TRT 100 ED 6P, TRT 100 ED 8P, TRT 150 ED 6P, and TRT 150 ED 8P near housing or places of work, always install adequate noise abatement devices or provide suitable personal protective equipment.

Caution: this symbol indicates precautions that must be taken to avoid damaging the appliance.

• Do not make modifications of any kind to this appliance.
• Regularly inspect the appliance for visible defects. If any faults are found, do not operate the appliance and contact Vortice* immediately.
• If the appliance does not function correctly or develops a fault, contact Vortice* immediately. Ensure that only genuine original Vortice spares are used for any repairs.
• Should the appliance be dropped or suffer a heavy blow, have it checked by Vortice* immediately.
• The appliance must be installed by a professionally qualified electrician.
• The electrical system to which the appliance is connected must conform to applicable standards.
• Note thatcurrent ele ctrical safety standards require the appliance to be earthed. If in doubt, ask a qualified electrician to check your system.
• The electrical power supply to which the appliance is to be connected must be able to provide the maximum electrical power required by the appliance. If it cannot do so, arrange for a qualified electrician to make the necessary modifications.
• Use a multi-polar switch with minimum contact gaps of 3 mm to install the appliance.
• The fan is approved for maximum operation time of 120 minutes at a temperature of 400°C; ensure that the power cables used are suited to the application type.
• Like all machines with moving parts, the fan may generate vibrations. To prevent vibrations being transmitted to the building structure, fit the fan with a vibration-damping system (fig. 8).
• Do not cover or obstruct the air intake or delivery grilles on the appliance.
• Switch off the appliance at the installation’s main switch: a) if the appliance does not function correctly; b) before cleaning the outside of the appliance; c) if the appliance is not to be used for any length of time.

N.B.

• Single-phase fans are fitted with condensers; note however that condensers are not connected to the motor. Install the condenser away from the fan, to prevent damage due to the high temperature of fumes (400°C) extracted.
• Connect up the condenser at the time of installation; refer to the diagram in fig. 12

STANDARD APPLICATIONS AND INSTALLATION

Specifications for the power supply must correspond to the electrical data on data plate A.

Operation at minimum speed is permitted for appliances used for cold air treatment (fans not intended for the intake of hot fumes 400°C / 2h) in countries not adopting European regulation no. 327/2011/EU.

MAINTENANCE / CLEANING

Maintenance and cleaning operations should be performed by professionally qualified personnel only

DISPOSAL

IMPORTANT INFORMATION CONCERNING THE ENVIRONMENTALLY COMPATIBLE DISPOSAL

• IN CERTAIN EUROPEAN UNION COUNTRIES THIS PRODUCT DOES NOT FALL WITHIN THE REQUIREMENTS OF THE NATIONAL LAWS IMPLEMENTING DIRECTIVE WEEE, AND IN THESE COUNTRIES THE PRODUCT IS NOT SUBJECT TO SEPARATE DISPOSAL OPERATIONS AT THE END OF ITS WORKING LIFE.
• This product complies with Directive 2012/19/EU on the management of waste electrical and electronic equipment (WEEE).
• The crossed-out wheeled bin symbol on the appliance indicates that, at the end of its life, the product should not be discarded together with household waste but must be taken to a separate collection point for electrical and electronic equipment. This will avoid negative effects on the environment and health, and will encourage correct treatment, disposal and recycling of the materials from which the product is made.
• Contact the municipal authority for the location of this type of facility. Alternatively, the distributor is obliged to take back the appliance to be disposed of free of charge in exchange for the purchase of an equivalent appliance.

ABOUT COMPANY

• VORTICE S.p.A.
  • Strada Cerca, 2 – frazione di Zoate
  • 20067 – Tribiano (MI)
  • Tel. +39 02-90.69.91
  • ITALY
  • vortice.com
  • postvendita@vortice-italy.com
• VORTICE INDUSTRIAL Srl
  • Via B. Brugnoli, 3
  • 37063 – Isola della Scala (VR)
  • Tel. +39 045 6631042
  • ITALY
  • vorticeindustrial.com
  • info@vorticeindustrial.com
• VORTICE VENTILATION SYSTEM (CHANGZHOU) CO.LTD
  • Building 19, No.388 West Huanghe Road, Xinbei District,
  • Changzhou, Jiangsu Province CAP:213000
  • CHINA
  • vortice-china.com
  • vortice@vortice-china.com
• VORTICE LIMITED
  • Beeches House-Eastern Avenue
  • Burton on Trent – DE 13 0BB
  • Tel. +44 1283-49.29.49
  • UNITED KINGDOM
  • vortice.ltd.uk
  • sales@vortice.ltd.uk
• VORTICE LATAM S.A.
  • Bodega #6
  • Zona Franca Este Alajuela – Alajuela 20101
  • Tel. (+506) 2201 6934
  • COSTA RICA
  • vortice-latam.com
  • info@vortice-latam.com
• CASALS VENTILACIÓN INDUSTRIAL IND., S.L.
  • Ctra. Camprodon, s/n
  • 17860 – Sant Joan de les Abadesses (Girona)
  • SPAIN
  • casals.com
  • ventilacion@casals.com

WARRANTY – OTHER COUNTRIES

The consumer has by law, free of charge, the legal guarantee of conformity with the seller, as described in Directive (EU) 2019/771 in force since January 1, 2022. In EU member countries also refer to local regulations.

References

• Casals Ventilación - Fabricante de Sistemas de Ventilación
• index- Your adventure begins here
• VORTICE LATAM - Aire es Vida
• Vortice ventilation, fans and air conditioners
• Vortice Industrial | Better air for Better life

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>