VORTICE Mex Punto Evo Flexo 120 5 LL 1S with Timer Instruction Manual

May 15, 2024
VORTICE

VORTICE-logo

VORTICE Mex Punto Evo Flexo 120 5 LL 1S with Timer

VORTICE-Mex-Punto-Evo-Flexo-120-5-LL-1S-with-Timer-
product

Product Information

Specifications

  • Model : MEX
  • COD : 5,671,084,388
  • Date : 11/16/2023

Product Usage Instructions

Before Using the Product

Before using the product, carefully read the instruction booklet provided. Failure to follow the instructions may result in damage to property or personal injury.

Storage

Always store the instruction booklet in a safe place to ensure easy access and reference when needed.

Maintenance

Regular maintenance is essential for long service life and optimal performance of the product. Follow the maintenance guidelines outlined in the instruction booklet.

Safety Precautions

Ensure that the product is used in accordance with the safety instructions provided in the manual to prevent accidents or damage.

FAQ

  • Q: What should I do if the product malfunctions?
    • A : In case of product malfunction, refer to the troubleshooting section of the instruction booklet or contact customer support for assistance.
  • Q: How often should I perform maintenance on the product?
    • A : Regular maintenance should be performed as per the guidelines provided in the instruction booklet. Typically, maintenance should be done at least once every [specified time frame].

Read the instructions contained in this booklet carefully before using the appliance. Vortice cannot assume any responsibility for damage to property or personal injury resulting from failure to abide by the instructions given in this booklet.
Following these instructions will ensure a long service life and overall electrical and mechanical reliability.

Keep this instruction booklet in a safe place.

Description and use

The appliance you have purchased is a single-speed in-line extractor fan designed for direct extraction (outside or into short ducts), compatible with wall / panel, false wall, ceiling and false ceiling installation.

The appliance is protected against jets of water (IP45 protection rating), so it is suitable for rooms with a high degree of humidity. All the models are equipped with a motor with ball bearings. The range consists of 4 models, with a standard diameter of 100 and 120 mm, in basic and Timer versions (see “Installation” and “Use” for a detailed description of the various functions):

  • MEX 100/4″ LL 1S
  • MEX 100/4″ LL 1S T
  • MEX 120/5″ LL 1S
  • MEX 120/5″ LL 1S T

These appliances are designed for use in residential and commercial properties.

Safety

Warning: this symbol indicates that care must be taken to avoid injury to the user

  • Do not use this appliance for functions other than those described in this booklet.
  • After removing the appliance from its packaging, ensure that it is intact and undamaged. If in doubt, immediately contact a professionally qualified electrician or an authorized Technical Support Centre.
  • Do not leave packaging within the reach of children or differently able persons.
  • Certain fundamental rules must be observed when using any electrical appliance, including: a) never touch appliances with wet or damp hands; b) never touch appliances while barefoot.
  • Store the appliance out of the reach of children and differently able persons if you decide to disconnect it from the power supply and use it no more.
  • Do not operate the appliance in the presence of flammable substances or vapors, such as alcohol, insecticides, petrol, etc.
  • Precautions must be taken to prevent gas coming from the gas flue pipe or from other fuel combustion units from entering into the room.
  • This appliance may be used by children over 8 years of age and by individuals with limited physical, sensory or mental capacities, or by inexperienced or untrained individuals, provided that they are supervised or have been instructed in safe use of the appliance and understand the associated risks.
  • Children must not play with the appliance.
  • Cleaning and maintenance procedures – for which the user is responsible – must not be carried out by children unless supervised.
  • Installation of the appliance in bathrooms (where there are bathtubs or showers) must be in accordance with current regulations.

Caution: this symbol indicates that care must be taken to avoid damaging the appliance

  • Do not make modifications of any kind to this appliance.
  • Do not expose this appliance to the elements (rain, sun, etc.).
  • Regularly inspect the appliance for visible defects. If any faults are found, do not operate the appliance but contact a Vortice-authorised Technical Support Centre immediately.
  • If the appliance malfunctions and/or develops a fault, contact a Vortice-authorized Technical Support Centre immediately. Ensure that only genuine original Vortice spares are used for any repairs.
  • Should the appliance be dropped or suffer a heavy blow, have it checked immediately by a Vortice Authorised Technical Support Centre.
  • The electrical system to which the appliance is connected must conform to applicable standards.
  • The appliance is double insulated and therefore does not need to be earthed.
  •  Connect the appliance to the electrical power supply/socket only if the rated power of the supply is sufficient to match the maximum rated power of the appliance. If not, contact a professional electrician without delay.
  • Switch off the appliance at the main switch: a) if the appliance does not function correctly; b) before cleaning the outside of the appliance, c) if the appliance is not to be used for any length of time.
  • The room must have an adequate source of replacement air for this appliance to function effectively. In the event that other non-sealed combustion-based appliances (such as water heaters, gas stoves, etc.) are installed in the same room, check that air replacement is sufficient for all appliances to work effectively together.
  • The appliance must either exhaust directly to the outside or into a short duct (max 400 mm to ensure the certified technical data; efficiency losses will occur if the appliance is installed in ducting subject to any appreciable level of back pressure).
  • The appliance cannot be used to control water heater switches, heaters, etc.; neither must it expel air into the hot air ducts of such appliances.
  • The air or fumes to be extracted from the room must be clean (i.e. free of grease, soot, chemical and corrosive agents, and explosive or flammable mixtures) and must not exceed a temperature of 50°C (122°F).
  • Keep the appliance’s intake and outlet grilles free to ensure an optimum flow of air.
  • Specifications for the power supply must correspond to the electrical data on ID plate A (Fig.1)
  • The appliance must be installed by a professionally qualified electrician.
  • A multi-pole switch must be used to install the appliance. The contact opening gap must be no less than 3 mm.

Items supplied

The fan unit is enclosed in a plastic cylinder incorporated in the motor carrier, which can be entirely accommodated in the destination pipe and whose short length makes it perfectly compatible with installation near elbow bends (90°), typical of pipe fittings.

The main parts of the appliance are:

  • Motor carrier and front panel, made of ABS thermoplastic, impact resistant and anti-UV resin;
  • Centrifugal rotor made of PP resin, designed for high performance, low power consumption, and low noise emissions;
  • Motor with shielded poles, equipped with ball bearings, and fitted with a thermal fuse.
  • PCB (T models).

Installation

VORTICE-Mex-Punto-Evo-Flexo-120-5-LL-1S-with-Timer-
fig3

VORTICE-Mex-Punto-Evo-Flexo-120-5-LL-1S-with-Timer-
fig4 VORTICE-Mex-Punto-Evo-Flexo-120-5-LL-
1S-with-Timer-fig5 VORTICE-Mex-Punto-Evo-
Flexo-120-5-LL-1S-with-Timer-fig6 VORTICE-Mex-Punto-Evo-Flexo-120-5-LL-1S-with-Timer-
fig9

Figg. 2 ÷ 13

N.B. whatever the orientation of the appliance, the non-return valve must always be in a vertical position (Fig. 8, 9).

VORTICE-Mex-Punto-Evo-Flexo-120-5-LL-1S-with-Timer-
fig6 VORTICE-Mex-Punto-Evo-Flexo-120-5-LL-
1S-with-Timer-fig7
N.B. if the non-return valve should come out of place and/or split into its halves, it will be possible to reposition it as shown in Fig. 9a, 9b.

VORTICE-Mex-Punto-Evo-Flexo-120-5-LL-1S-with-Timer-
fig8

Trimmer settings (T models)

There is a trimmer on the PCB that can be used to adjust the duration of the switch-off delay (factory set to 3 minutes). The delay duration can be adjusted up to approximately 20 minutes using the trimmer (Fig. 14).

Use

  • Basic models
    • This appliance is operated by switching it on using the power switch.
  • Timer models
    • This appliance is operated by switching it on using the power switch. The integrated timer controls the switch-off delay. After it is switched off by means of the switch, the appliance will therefore continue to run for the set amount of time.

Electrical connections

Fig. 15 ÷ 16

VORTICE-Mex-Punto-Evo-Flexo-120-5-LL-1S-with-Timer-
fig11

Maintenance and cleaning

Fig. 17 ÷ 19

VORTICE-Mex-Punto-Evo-Flexo-120-5-LL-1S-with-Timer-
fig12

Disposal

This product complies with Directive 2012/19/EU on the management of waste electrical and electronic equipment (WEEE).

The crossed-out wheeled bin symbol on the appliance indicates that, at the end of its life, the product should not be discarded together with household waste but must be taken to a separate collection point for electrical and electronic equipment. This will avoid negative effects on the environment and health and will encourage correct treatment, disposal, and recycling of the materials from which the product is made.

Contact the municipal authority for the location of this type of facility. Alternatively, the distributor is obliged to take back the appliance to be disposed of free of charge in exchange for the purchase of an equivalent appliance.

VORTICE S.p.A. reserves the right to make improvements to products at any time and without prior notice.

VORTICE GROUP COMPANIES

VORTICE S.p.A.

  • Strada Cerca, 2 – frazione di Zoate 20067 – Tribiano (MI)
  • Tel. +39 02-90.69.91

ITALY

VORTICE INDUSTRIAL Srl

  • Via B. Brugnoli, 3 37063 – Isola della Scala (VR)
  • Tel. +39 045 6631042

ITALY

VORTICE VENTILATION SYSTEM (CHANGZHOU) CO.LTD Building 19, No.388 West Huanghe Road, Xinbei District, Changzhou, Jiangsu Province CAP:213000
CHINA

VORTICE LIMITED

  • Beeches House-Eastern Avenue Burton on Trent – DE 13 0BB
  • Tel. +44 1283-49.29.49

UNITED KINGDOM

CASALS VENTILACIÓN INDUSTRIAL IND., S.L. Ctra. Camprodon, s/n

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals