HOGYME 7 ft x 4.2 ft Metal Outdoor Storage Shed User Manual
- June 9, 2024
- HOGYME
Table of Contents
*Instruction for Assembly 4.2′ 7′ Metal Shed
Model Number:
HG61X0651, HG61S0647, HG61M0643
User Manual**
Assembly Preparation
Please check local building codes regarding footings, location and other
requirements before beginning construction.
Assembly instructions:
Reviewing all instructions and the appropriate information before you begin,
make sure following the step sequence carefully for successful results.
Flooring base:
A good location for the storage building is a square and level area with good
drainage. The base is not included i n the kit which may need purchase
separately or may construct a foundation and anchoring system of your own.
A strong plastic sheet (thickness: at least 150m) should be placed under the
foundation to assist in reducing rising dampness from the soil, thus reducing
condensation build up in the shed. Your storage building must be anchored to
prevent wind damage. Once secured, it is highly recommended applying silicone
along the inside of the base rail to minimize condensation.
Parts and Parts List:
Before you start, separate and identify all the parts and hardware tobe sure
that you have all the necessary parts for your building (refer to the Parts
List Page).
If you find that apart is missing, please notify the seller within one week
after receiving the product.
Do not attempt t o assemble the building if parts are missing because any
building left partially assembled may be seriously damaged by light winds.
Tools you need:
( Please tear off the safety protection layer before the assembly, keep the
part number label if needed )
Safety must be put in the No. 1 position:
-
Select a dry and calm day for your assembly. Team works (Two or more people) are required during the assembly. It is also recommended to finish the assembly in a day to avoid damage to the product or missing of some small parts.
-
Wearing safety gloves, eye protection and long sleeves during the assembly to prevent injury.
Pay attention to the sharp edge of some parts. -
Children and pets are not allowed entering into the construction site.
-
Never concentrate your total weight on the roof of the building. When using a step ladder make sure that it is safe.
Care & Maintenance:
- Keep the shed clean with soft cloth, use water if necessary. Keep the door tracks clear of dirt and other stuff that prevent them from sliding easily.
Clean the snow with necessary tools to make sure it is safe to enter into. The
shed is not made for living but storing stuff.
Please add some oil on the top and bottom door sliding channel t o make door
slides smoothly.
Size :
Area of installation requirement:
PRODUCT ASSEMBLY
Hardware List
PRODUCT ASSEMBLY
The floor frame must be level and square or holes will not align.
(Notice: Measure the floor frame diagonally. When the diagonal
measurements are equal, the floor frame i s square.)
Make the colored side of
the steel plate outward.
Put the side with fewer
holes facing up.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>