TIS TMR-AUT-T Automation Timer Installation Guide
- June 13, 2024
- TIS
Table of Contents
TIS TMR-AUT-T Automation Timer
PRODUCT SPECIFICATIONS
| Conditions links| AND, OR, NAND, NOR
---|---|---
| Programming sections| 12
Logic
| Table in each sections| 20
| Pins of table| 4
| Conditions type| If “year, month, week, day, time, channel, curtain,
universal switch, security, flag switch”
| Number of devices on 1 line| Max. 64
TIS Bus
| Bus voltage| 12-32 V DC
| Current consumption| <25mA/24V DC
| Protection| Reverse polarity protection
**** Function programmable options
| Commands| 10 commands per table
| Advanced Timer| Longitude latitude info, setting for sunset sunrise
calculation
Dimensions
| Width × length × height| 76mm × 69mm × 90mm
| Materials| Fireproof ABS
Housing
| Casing color| Black
| IP rating| IP 20
Air humidity
| | <85%non-condwnsing
INSTALLATION
Read Instructions
We recommend that you read this Instruction Manual before installation.
Safety instructions
Electrical equipment should only be installed and fitted by electrically
skilled persons.
Failure to observe the instructions may cause damage to the device and other
hazards.
These instructions are an integral part of the product and must remain with
the end customer.
Programming
Advanced programming requires TIS Device Search software. Advanced software
programming knowledge should be obtained in the advanced training courses.
Simple Installation
DIN Rail mount facilitates installation.
Fixing points are provided for installation without the use of DIN rail.
Mounting Location
Install in a dry, well-ventilated location.
Controllers may emit some mechanical noise. Take this into account when
deciding on a mounting location.
Data Cable
Use screened stranded RS485 data cable with four twisted pairs. Configure
devices in a “Daisy Chain.”
Do not cut or terminate live data cables.
Warranty
We provide a warranty as required by law.
A hologram warranty seal and product serial number are provided on each
device. Please send the description of the defect with Product S/N to our
dealer network.
INSTALLATION STEPS
-
Turn off TIS power supply.
WARNING! HIGH VOLTAGE -
Mount the device on a DIN rail inside an approved enclosure. The device can also be installed without the use of DIN rail by two mounting screw holes.
-
Connect a Cat5e TIS network data cable to the TIS-BUS port as per the connection diagram. No need to loop the TIS-bus cable if 2 DIN rail modules are connected together from the side bus train terminal.
TROUBLESHOOTING
PRG Button Blinks Red Color Rapidly
Reason: The module’s address conflicts with another device in the TIS network. You need to press and hold the PRG button for 6 seconds so the module can get a new address.
Device PRG LED is not Blinking; Device not Powered
Reason: Device is not powered on; no TIS-BUS 24V supply connected to the device.
Wall Panels can’t Communicate with the Device
Reason 1: The TIS-BUS connection has a problem;
check the wires and make sure there’s not a short in the connection.
Reason 2: The programming address is wrong
Device Time Resets to Default Randomly
Reason: The built-in battery has expired. You need to add an external battery or replace the built-in battery with a new one.
Copyright © 2022 TIS, All Rights Reserved
TIS Logo is registered trademark of TIS CONTROL.
All of the specification are subject to change without notice.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>