DENALI ASC5358B-00 SKIL 20V 2.4A Standard Charger Instruction Manual
- June 9, 2024
- DENALI
Table of Contents
DENALI ASC5358B-00 SKIL 20V 2.4A Standard Charger
Important Safeguards
Read these instructions carefully and retain them for future use. If this charger is passed to a third party, then these instructions must be included.
WARNING
Read all safety warnings and all instructions.
Failure to follow all instructions listed below may result in electric shock,
fire and/or serious injury.
-
Do not recharge non-rechargeable batteries.
-
This charger is not a toy. Children should be supervised to ensure that they do not play with the charger.
-
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
-
Examine the battery charger regularly for damage, especially the cord, plug and enclosure. If the battery charger is damaged, it must not be used until it has been repaired.
-
Use chargers only with specifically designated battery packs. Use of any other battery packs may create a risk of injury and fire.
-
Do not use a battery pack or charger that is damaged or modified. Damaged or modified batteries may exhibit unpredictable behaviour resulting in fire, explosion or risk of injury.
-
Do not expose a battery pack or charger to fire or excessive temperature. Exposure to fire or temperature above 265° F (130° C) may cause explosion.
-
Do not use this charger in damp or wet environment.
-
Do not expose charger to rain or snow. Water entering the charger may result in electric shock or fire.
-
Follow all charging instructions and do not charge the battery pack or use the charger outside of the temperature range specified in the instructions. Charging improperly or at temperatures outside the specified range may damage the battery and increase the risk of fire.
-
Have servicing performed by a qualified repair person using only identical replacement parts.
This will ensure that the safety of the charger is maintained. -
This charger is intended to be correctly orientated in a vertical or floor mount position.
-
Place charger on flat non-flammable surfaces and away from flammable materials. Carpeting and other heat insulating surfaces block proper air circulation which may cause overheating of the charger and battery pack. If smoke or melting of the charger or battery pack is observed, unplug the charger immediately and do not use the battery pack or charger.
-
Do not touch the uninsulated portion of charging pins or insulated battery terminals.
There is a risk of electric shock.
Extension cords
WARNING
AN EXTENSION CORD SHOULD NOT BE USED UNLESS ABSOLUTELY NECESSARY. Use of
improper extension cord could result in risk of fire and electrical shock. If
an extension cord is used, make sure:
- a. The pins on plug of extension cord are the same number, size, and shape as those of plug on charger.
- b. The extension cord is properly wired and in good electrical condition.
-
c. The wire size is large enough for AC ampere rating of charger as specified below:
Extension Cord Chart for 120 Volt Tools:Length of Cord| 25′ 50′
(7.6 m) (15 m)
| 100′
(30 m)
| 150′
(45 m)
Size of Cord (AWG)| 18 16| 16| 14
- d. An extension cord is a temporary solution.
Move the charger to a standard receptacle/outlet as soon as the charging has been completed.
Charger Description
- A. Battery slot
- B. Defect indicator
- C. Charging indicator
- D. Supply cord with plug
Intended Use
This charger is intended for charging the following battery pack models only. Do not attempt to charge other battery packs with this charger.
- This charger is intended for household use only.
- This charger is intended to be used in dry indoor areas only.
Before First Use
DANGER Risk of suffocation!
Keep any packaging materials away from children and pets – these materials are a potential source of danger, e.g. suffocation.
- Remove all the packing materials.
- Remove and review all components before use.
- Check the charger for transport damages.
Operation
Charging a battery pack
CAUTION Risk of injury and fire!
Use this charger only with specifically designated battery packs. Use of any
other battery packs may create a risk of injury and fire.
NOTICE The charger may become warm after several continuous charging
cycles.
This is normal. Use the charger in a well-ventilated area.
- Connect the plug (D) to a suitable socket outlet. The defect indicator (B) and the charging indicator (C) flash once. The charger is ready for charging.
- Align the raised ribs of the battery pack with the battery slot (A) of the charger then slide the battery pack into the slot (Fig. 1).
- The charger automatically checks the condition of the battery pack. If the battery pack is within the charging temperature range, the charging indicator (C) flashes green. The battery pack is being charged.
- The battery pack is full when the charging indicator (C) stays on green.
- Slide the battery pack off from the charger (Fig. 2).
- Unplug the charger from the socket outlet when not in use.
NOTICE I it the battery pack cannot be charged, the contacts of the charger or battery pack may be contaminated.
Clean the contacts of the charger or battery pack by inserting and removing the battery several times or by cleaning with a cotton swab and alcohol.
Indicator guide
Wall mounting
NOTICE The mounting surface must be strong enough to hold the combined weight of the charger and the battery pack.
- Wall mount holes are located at the back o f the charger (Fig. 4). If desired, install screws in the wall 2.25″ (57.1 mm) apart to hang the charger.
- Supply cord retainer is also located at the back o f the charger for convenient supply cord routing (Fig. 4).
Cleaning and Maintenance
NOTICE
Unplug the charger before cleaning. During cleaning do not immerse the charger
in water or other liquids. Never hold the charger under running water.
Cleaning the housing
- To clean the charger, wipe with a soft, slightly damp cloth.
- Wipe the charger dry after cleaning.
- Never use corrosive detergents, wire brushes,abrasive scourers, metal or sharp utensils to clean the charger.
NOTICE
The charger may be cleaned most effectively with compressed dry air. When
doing so, do not exceed the pressure of 43 PSI (3 bar) and always wear safety
goggles.
Certain cleaning agents and solvents damage plastic parts. Some of these are: gasoline, carbon tetrachloride, chlorinated cleaning solvents, ammonia and household detergents that contain ammonia. Do not use cleaning agents and solvents containing these, as they can damage the charger.
Storage
- Detach the battery pack from the charger before storage.
- Store the charger in its original packaging in a dry area. Keep away from children and pets.
Plug fuse replacement (for U K only)
- Use a flat screwdriver to open the fuse compartment cover.
Transport
- Detach the battery pack from the charger before transportation.
- Make sure the charger is strapped in firmly during transit.
- Avoid vibrations and shocks.
Maintenance
- Any other servicing than mentioned in this manual should be performed by a professional repair center.
Frequently Asked Questions
FCC – Supplier’s Declaration of Conformity
FCC Compliance Statement
- This device complies with Part 1 S of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
- Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
FCC Interference Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio / TV technician for help.
DANGER
People with electronic devices, such as pacemakers, should consult their
physician(s) before using this charger. Operation of electrical equipment in
close proximity to a heart pacemaker could cause interference or failure of
the pacemaker.
Canada IC Notice
This Class B digital apparatus complies with Canadian CAN ICES-003(B)/
NMB-O03(B) standard.
Disposal
The Waste Electrical and Electronic Equipment (WEEE) Directive aims to minimise the impact of electrical and electronic goods on the environment, by increasing re-use and recycling and by reducing the amount of WEEE going to landfill. The symbol on this product or its packaging signifies that this product must be disposed separately from ordinary household wastes at its end of life. Be aware that this is your responsibility to dispose of electronic equipment at recycling centres in order to conserve natural resources. Each country should have its collection centres for electrical and electronic equipment recycling. For information about your recycling drop-off area, please contact your related electrical and electronic equipment waste management authority, your local city office, or your household waste disposal service.
Specifications
For North American market
For European and United Kingdom market
Feedback and Help
We would love to hear your feedback. To ensure we are providing the best
customer experience possible,please consider writing a customer review.
Scan QR Code below with your phone camera or QR reader:
UK: amazon.co.uk/review/review-your-purchases#
If you need help with your Denali product, please use the website or number
below.UK: amazon.co.uk/review/review-your-
purchases#
If you need help with your Denali product, please use the website or number
below.
US: amazon.com/gp/help/customer/contact-
us
UK: amazon.co.uk/gp/help/customer/contact-
us
+1 877-485-0385 (US Phone Number)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>