DENALI HMT.23.10100 Harley Davidson Pan America Horn Mounting Bracket Instruction Manual
- June 3, 2024
- DENALI
Table of Contents
DENALI HMT.23.10100 Harley Davidson Pan America Horn Mounting Bracket
Thank you for choosing DENALI
We know you would rather be riding your bike than wrenching on it, so we go
the extra mile to make sure our instructions are clear and as easy to
understand as possible. If you have any questions, comments, or suggestions
don’t hesitate to give our gear experts a call at 401.360.2550 or visit
WWW.DENALIELECTRONICS.COM
Please Read Before Installing
DENALI products should always be installed by a qualified motorcycle
technician. If you are unsure of your ability to properly install a product,
please have the product installed by your local motorcycle dealer. DENALI
takes no responsibility for damages caused by improper installation. Caution:
When installing electronics it is extremely important to pay close attention
to how wires are routed, especially when mounting products to the front
fender, front forks, or fairing of your motorcycle. Always be sure to turn the
handlebars fully left, fully right, and fully compress the suspension to
ensure the wires will not bind and have enough slack for your motorcycle to
operate properly.
Installation Tips
We strongly recommend using a medium-strength liquid thread locker on all screws, nuts, and bolts. It is also important to ensure that all hardware is tightened to the proper torque specifications as listed in your owner’s manual. For included accessory hardware please refer to the default torque specifications provided below. Inspect all hardware after the first 30 miles to ensure proper torque specifications are maintained.
Hardware Sizing Guide
Not sure what size bolt you have? Use this ruler to measure screws, bolts, spacers, etc. Remember, the length of a screw or bolt is measured from the start of the “mounting surface” to the end of the screw, so only include the screw head when measuring countersunk screws.
What’s In The Box
Kit Contents
- Horn Mounting Bracket…….(HMT.23.002)………………………….Qty 1
- M8x30mm DIN 933 Hex Head Screw…………………………………Qty 1
- M8 Washer DIN 125…………………………………………………….Qty 1
- M8 Spacer………………………………………………………………..Qty 1
Tools Required: 13mm Wrench(s)
Mounting the Bracket
Bracket Installation
-
Step One: Remove the factory bolts from the mounting locations.
Note: The right side flanged bolt from the frame will be reused to mount the bracket. -
Step Two: Mount your horn bracket using the kits M8x30mm Hex Head Bolt(b), M8 Washer(c) and M8 Spacer(d) as well as the factory flanged bolt from the bike’s frame that was previously removed.
Mounting The Horn
Horn Installation
Step One: Use the hardware supplied with the SoundBomb Horn to attach it
to the bracket. Use a 13mm wrench to tighten the nut on the back side of the
mount.
Note: Before fully tightening the horn, you can make small adjustments by
slightly rotating the horn to better match the profile of your bike. The horn
should not exceed 10 degrees of tilt and should be as close to 90 degrees
upright as possible. When happy with the position make sure to fully tighten
the horn.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>