DENALI HMT.04.10500 KTM 1290 Super Adventure R Upper Light Mounting Bracket Instruction Manual

June 4, 2024
DENALI

DENALI HMT.04.10500 KTM 1290 Super Adventure R Upper Light Mounting

Bracket

DENALI HMT.04.10500 KTM 1290 Super Adventure R Upper Light Mounting
Bracket

WHAT’S  IN THE BOX

DENALI HMT.04.10500 KTM 1290 Super Adventure R Upper
Light Mounting Bracket 1

Tools Required

3mm Hex Bit

Installing The Light Mount 

DENALI HMT.04.10500 KTM 1290 Super
Adventure R Upper Light Mounting Bracket 2

Location Prep & Installation

  • Step One: Locate the three mounting points for each bracket and remove the factory screws. Two are located below on the inner fairing and one is on the left and right side of the headlight housing.
  • Step Two: Mount your Brackets (a,c) in place using the provided hardware. Each mounting point will get a spacer (b) between the mounting surface and the bracket and an M5 washer (d) and M5 x 25mm Button Head screw (e) to secure the Bracket in place.

Thank you for choosing DENALI
We know you would rather be riding your bike than wrenching on it, so we go the extra mile to make sure our instructions are clear and as easy to understand as possible. If you have any questions, comments, or suggestions don’t hesitate to give our gear experts a call at 401.360.2550 or visit WWW.DENALIELECTRONICS.COM

Please Read Before Installing

DENALI products should always be installed by a qualified motorcycle technician. If you are unsure of your ability to properly install a product, please have the product installed by your local motorcycle dealer. DENALI takes no responsibility for damagescaused by improper installation. Caution: When installing electronics it is extremely important to pay close attention to how wires are routed, especially when mounting products to the front fender, front forks, or fairing of your motorcycle. Always be sure to turn the handlebars fully left, fully right, and fully compress the suspension to ensure the wires will not bind and have enough slack for your motorcycle to operate properly.

Installation Tips

We strongly recommend using medium strength liquid thread locker on all screws, nuts, and bolts. It is also important to ensure that all hardware is tightened to the proper torque specifications as listed in your owner’s manual. For included accessory hardware please refer to the default torque specifications provided below. Inspect all hardware after the first 30 miles to ensure proper torque specifications are maintained.DENALI HMT.04.10500
KTM 1290 Super Adventure R Upper Light Mounting Bracket
3

Hardware Sizing Guide
Not sure what size bolt you have? Use this ruler to measure screws, bolts, spacers, etc. Remember, the length of a screw or bolt is measured from the start of the “mounting surface” to the end of the screw, so only include the screw head when measuring countersunk screws.

DENALI HMT.04.10500 KTM 1290 Super Adventure R Upper Light Mounting Bracket
4

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

DENALI User Manuals

Related Manuals