DENALI HMT.11.10600 Sound Bomb Horn Mount Instruction Manual
- June 1, 2024
- DENALI
Table of Contents
**DENALI HMT.11.10600 Sound Bomb Horn Mount Instruction Manual
**
Thank you for choosing DENALI
We know you would rather be riding your bike than wrenching on it, so we go the extra mile to make sure our instructions are clear and as easy to understand as possible. If you have any questions, comments, or suggestions don’t hesitate to give our gear experts a call at 855.255.5550 or visit DenaliElectronics.com/instructions.
Please Read Before Installing
DENALI products should always be installed by a qualified motorcycle
technician. If you are unsure of your ability to properly install a product,
please have the product installed by your local motorcycle dealer. DENALI
takes no responsibility for damages caused by improper installation.
Caution: When installing electronics is it extremely important to pay
close attention to how wires are routed, especially when mounting products to
the front fender, front forks, or fairing of your motorcycle. Always be sure
to turn the handlebars fully left, fully right, and fully compress the
suspension to ensure the wires will not bind and have enough slack for your
motorcycle to operate properly.
Installation Tips
We strongly recommend using medium strength liquid thread locker on all screws, nuts, and bolts. It is also important to ensure that all hardware is tightened to the proper torque specifications as listed in your owner’s manual. For included accessory hardware please refer to the default torque specifications provided below. Inspect all hardware after the first 30 miles to ensure proper torque specifications are maintained.
| Bolt Size | in-lbs | ft-lbs | Nm |
|---|---|---|---|
| M3 | 10.0 in-lbs | – | 1.0 Nm |
| M4 | 23.0 in-lbs | – | 2.5 Nm |
| M5 | 44.5 in-lbs | 3.5 ft-lbs | 5.0 Nm |
| M6 | 78.0 in-lbs | 6.5 ft-lbs | 9.0 Nm |
| M8 | – | 13.5 ft-lbs | 18.0 Nm |
| M10 | – | 30.0 ft-lbs | 41.0 Nm |
| M12 | – | 52.0 ft-lbs | 71.0 Nm |
Hardware Sizing Guide
Not sure what size bolt you have? Use this ruler to measure screws, bolts,
spacers, etc.
Remember, the length of a screw or bolt is measured from the start of the
“mounting surface” to the end of the screw, so only include the screw head
when measuring countersunk screws.
Kit Contents
(a) Bracket …………………………Qty 1
(b) M6x30 ISO 7380 ……………..Qty 1
(c) M6x40 ISO 7380 ……………………Qty 1\
Tools Required
- 4mm Allen Key
- 13mm Wrench
- 8mm Wrench
Mounting The Horn
Step One: Use the hardware included with the SoundBomb horn to attach the horn to the bracket (a) as illustrated above.
Note: Insert the mounting screws (b & c) into the bracket (a)
before attaching the horn.
Installing The Bracket
Step Two: Remove the two OEM bolts from the engine case on the left hand side of the motorcycle.
Step Three: Use the M6 screws (b & c) to attached the horn and
bracket to the motorcycle. The longer screw (b) g oes in the hole closer
to the front of the motorcycle. (Reference official Triumph resource for
proper torque specification).
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>