DENALI Kawasaki KLR650 SoundBomb Horn Mount Instruction Manual
- June 4, 2024
- DENALI
Table of Contents
DENALI Kawasaki KLR650 SoundBomb Horn Mount
What’s In The Box?
Kit Contents
- (a) Horn Mounting Bracket……(HMT.08.10300)………………………..Qty 1
- (b) M6x35mm Flanged Hex Head Screw DIN 6921…………………….Qty 2
- Tools Required: 10mm wrench, 13mm wrench
Thank you for choosing DENALI
We know you would rather be riding your bike than wrenching on it, so we go
the extra mile to make sure our instructions are clear and as easy to
understand as possible. If you have any questions, comments, or suggestions
don’t hesitate to give our gear experts a call at 401.360.2550 or visit
WWW.DENALIELECTRONICS.COM
Please Read Before Installing
DENALI products should always be installed by a qualified motorcycle
technician. If you are unsure of your ability to properly install a product,
please have the product installed by your local motorcycle dealer. DENALI
takes no responsibility for damages caused by improper installation. Caution:
When installing electronics it is extremely important to pay close attention
to how wires are routed, especially when mounting products to the front
fender, front forks, or fairing of your motorcycle. Always be sure to turn the
handlebars fully left, fully right, and fully compress the suspension to
ensure the wires will not bind and have enough slack for your motorcycle to
operate properly.
Installation Tips
We strongly recommend using medium strength liquid thread locker on all
screws, nuts, and bolts. It is also important to ensure that all hardware is
tightened to the proper torque specifications as listed in your owner’s
manual. For included accessory hardware please refer to the default torque
specifications provided below. Inspect all hardware after the first 30 miles
to ensure proper torque specifications are maintained.
| Bolt Size | in-lbs | ft- lbs | Nm |
|---|---|---|---|
| M3 | 10.0 in-lbs | – | 1.0 Nm |
| M4 | 23.0 in-lbs | – | 2.5 Nm |
| M5 | 44.5 in-lbs | 3.5 ft-lbs | 5.0 Nm |
| M6 | 78.0 in-lbs | 6.5 ft-lbs | 9.0 Nm |
| M8 | – | 13.5 ft-lbs | 18.0 Nm |
| M10 | – | 30.0 ft-lbs | 41.0 Nm |
| M12 | – | 52.0 ft-lbs | 71.0 Nm |
Hardware Sizing Guide
Not sure what size bolt you have? Use this ruler to measure screws, bolts,
spacers, etc. Remember, the length of a screw or bolt is measured from the
start of the “mounting surface” to the end of the screw, so only include the
screw head when measuring countersunk screws.
Installing The Horn Mount
Horn Installation
- Step One: Remove the two OEM bolts from the mounting location found on the crank case cover on the left side of the bike.
- Step Two: Use the two M6x35mm Flanged Hex Head screws (b) to attach the bracket to the motorcycle.
- Step Three: Use the hardware supplied with your Denali SoundBomb Compact Horn to attach the horn to the top hole of the mounting bracket.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>