Westfalia 501123 Solar LED Light TONY Instruction Manual

: June 9, 2024
: Westfalia

Table of Contents

Introduction
Safety instructions
Intended use
Start-up and runtime
Care
Technical data
Malfunctions
Replacing the battery
Disposal
Customer Support
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Westfalia 501123 Solar LED Light TONY

Westfalia 501123 Solar LED Light TONY

These operating instructions belong exclusively to the product. It contains important information on the commissioning and handling of the luminaire. Therefore, please pay attention to these operating instructions, even if you pass this product on to third parties. Please keep these instructions in a safe place for future reference.

Introduction

Dear customer, thank you for purchasing our product. You have purchased a product from Vollmer, which has been built according to the current state of the art. The luminaire meets the requirements of the applicable European and national directives. In order to maintain the condition of the product and to ensure safe operation, you as the user must observe these operating instructions!

Safety instructions

In case of damage caused by non-observance of these operating instructions, the warranty claim expires!
We do not assume any liability for consequential damages!
Do not bring the lamp into contact with extreme heat or open flame.
We accept no liability for damage to property or personal injury caused by improper handling or non-observance of the safety instructions.
In such cases, all warranty claims are void.
The entire product must not be modified or converted. Modifications to the product will void the warranty.
The type plate must not be removed.

Intended use

The solar luminaire is designed for outdoor use. The built-in rechargeable battery is charged by the solar cell in the base of the luminaire. The product switches on automatically at dusk and off again at dawn. Powerful light-emitting diodes (LEDs) are used as the light source. These LEDs guarantee high luminous intensity with low power consumption.

Please note, however, that if there is little sunlight on the solar module and in the winter months, the light duration / light output may be impaired.

Note: In longer periods without sunlight, the battery is insufficiently charged so that no constant operational readiness can be guaranteed. However, this does not mean that the solar luminaire is defective. Wait for the next sunny days and the luminaire will be usable again according to its function.

Start-up and runtime

Take the solar luminaire carefully out of the packaging.
Remove the protective film
Place the solar luminaire in the desired location, observing the safety and warning instructions, and operate the switch. (underside of the housing).
For initial charging, find a suitable location with direct sunlight.
Make sure that the solar unit of the solar LED luminaire is directly illuminated by the sun. Shadows on the solar unit will affect the charging function of the battery.
The solar LED luminaire is charged by the solar panel.
Due to the day/night sensor, it will turn on automatically at dusk.
Make sure the day/night sensor of the luminaire is not affected by any other light source. Otherwise, the luminaire will not turn on at dusk.
There is no possibility to change the lamp

Note: The light duration / light intensity is strongly dependent on the duration and intensity of sunlight during the day. In the winter time, a shorter luminous period is generally to be expected. If the lamp does not light up on the first evening, please wait for one or two sunny days.

Care

Use a damp cloth for cleaning.
Never use chemicals or scouring agents for cleaning.
The luminaire must be cleaned of dirt at regular intervals.
When using the luminaire outdoors, also pay attention to soiling, e.g. by leaves, and remove this regularly.
Protect the lamp from frost.

Technical data

Article| Power supply| LED| Protection type| Protection class
---|---|---|---|---
501123| 1x Li-ion Akku 18650, 3,7 V 1500 mAh,| 3 LED, 4000 K not changeable| IP44| III

Malfunctions

The luminaire does not light up or only lights up briefly:

Light switched on?
Battery weak or defective. Replace the battery
An external light source (e.g. street lamp) prevents the lamp from switching on. Therefore, move the lamp to a darker place. 8.

Replacing the battery

As a first step, switch off the panel on the underside.
To replace the battery, loosen the 4 Phillips screws on the underside of the solar panel.
Now remove the upper part, taking care not to damage the two cables between the upper and lower parts.
The battery compartment is now accessible. When replacing the battery, ensure that the polarity is correct.
The installation is done in reverse order.

Disposal

The symbol of the crossed-out dustbin means that you have a legal obligation to dispose of this equipment separately from unsorted municipal waste. Disposal in the residual waste bin or the yellow bin is prohibited. If the products contain batteries or rechargeable batteries that are not permanently installed, these must be discharged, removed and disposed of separately as batteries before disposal.