jakks PACIFIC 86905-PKC1-11L Super Mario Anti Gravity RC Racer Instructions
- June 5, 2024
- jakks PACIFIC
Table of Contents
jakks PACIFIC 86905-PKC1-11L Super Mario Anti Gravity RC Racer
TRY ME BATTERY BOX REMOVAL
- Open up box and remove the RACER and CONTROLLER from the box.
- Remove inner packaging until RACER and CONTROLLER are as shown above
- Using a Phi lips Head screwdriver (not included) love the BATTERY Cover on the RACER ard CONTROLLER and detach the wires on both,
- Push the power s tch c” the RACER to “OFF position. Remove the Racer AA batteries. Install fresh batteries in the RACER and CONTROLLER and replace the bate y covers on both, (see BATTERY INSTALLATION)
IMPORTANT INFORMATION
- Maximum Transmission power 2db, Frequency band: 2418-2462MHz
- CONTROLLER (86905TXA): x2 1.5V AA (LR6) ALKALINE BATTERIES REQUIRED (NOT INCLUDED)
- ANTI-GRAVITY RACER (86905 RXA): X6 1.5V C (LR14) ALKALINE BATTERIES REQUIRED (NOT INCLUDED)
Manufactured
©2022 and manufactured for / pour JAKKS PACEC. ING 2951 281THSIL SANTA MONICA CA 90405 USA. and designate U.S. trademarks of/ designed marques deposes aux EtaluSUnis de JAKKS Pacific. Other trademarks used under a license Autres marques deposes until sees so US license. MADE N CHINA, FABRIQUE EN CHINE. Imported into UK by /-Jni par JAKKS Pacific (UK) Ltd, 1 Afington Square, Downshire Way, Bracknell, Berkshire RG12 1WA, GB, and EU by/et UE par JAKKS Europe Bv, Herikerbergweg 88,1101 CM Am Amsterdam NL www.jakks.com wwwjakks.com/warranty consumers@jakks.com North America/ 1.377.875.2557 or 1.909.594.7771 UK& EU /Royaume-Uni et UE: 00440)1344A.638909 Colors & decoration may vary. Retain packaging/instructions for reference.WARNING! Small Parts.Choking Hazard
CONTROLLER BATTERY INSTALLATION
ADULT INSTALLATION REQUIRED
Requires 2-1.5V AA (LR6) ALKALINE BATTERIES. Batteries not included When
performance diminishes, replace with fresh batteries.
- Locate and open BATTERY COVER as shown, Use a Phillips Head shrewd Liver (not included) to loosen the screw. Screw remains attached to cover,
- Install 2-1.5V AA (LRG) ALKALINE BATTERIES in the orientation shown,
- Repace BATTERY COVER and tighten the screw.
RACER BATTERY INSTALLATION
- Make sure RACER is in OFF position. Locate BATTERY COVER underneath RACER as shown. Use a Phill ps Head screwdriver (not included) to loosen screws and HOve caver
- Install 6-1.5V C (LR14) ALKALINE BATTERIES in the orientation shown,
- Replace BATTERY COVER and tighten screws.
IMPORTANT SAFETY INFORMATION
Caution Not recommended for children under 8 years of age, Head I instructions before operating, Avoid fighting people. Fets o home furnishings. Never operate in the street, Keep hair, hands and clothing away from the vehicle when the power switch is turned ON, DO NOT pick up 0vng Venice, move Hatteras ani control Attencs when vehicle: is to e stomach tor an extended period, Do not store, VERJCLE WOHKS BEST ON SMOOTH, FLAI, CLEAN, DRY SURFACES, FREE OF DIRECTION AND DUST. NOT INTENDED FOR USE ON CARPET.
OPERATING THE ANTI-GRAVITY RACER
- Turn the CONTROLLER power SW tch to the “ON” position
- Turn the POWER switch on the bottom of the RACER :0 he ON” position
- When the RACER and CONTROLLER are turned ON, the power light on the CONTROLLER vill 1ash 0 sync RACER. When the power light stops fashion and remains ON,
The Controller
- Press the RIGHT TOP button to turn the wheels into
- ANT-GRAVITY mode.
- Press the LEFT TOP button to turn the wheek into
- STANDARD mode.
- Shift the LEFT to command forward or reverse.
- Shift the Right or Left
Turning Racer On
Push the ON/OFF/TRY ME button to the ON position.
OPERATING THE ANTI-GRAVITY RACER AND PERFORMING STUNTS
- Shift LEFT stick to go FORWARD/REVERSE. Shift RIGHT stick to go LEFT/RIGHT
- Shift and hold the RIGHT stick in either direction.
- Press the TOP RIGHT button to turn wheels into anti-gravity mode. Press TOP LEFT buton to retun wheels to standard mode.
- Drive forward, press the TOP RIGHT button to turn the wheels into anti-gravity mode then shit the RIGHT stick to the LEFT
- Press the TOP RIGHT button to turn wheels into anti-gravity mode, shiít the LEFT stick forward and the RAGHT stick LEFT or RIGHT at the same time,
- STANDARD DRIVING MODE
- 360 SPINS
- ANT-GRAVITY MODE
- POWER SLIDES
- ANTL-GRAVITY SPiMS
TROUBLESHOOTING
- LOoset battery connection
- Check battery connection
- The vehicle will not run or SCems sluggish
- Move the switch to the “ON’ position
- MOve switch to the “ON” position
- Vehicle battery weak
- Replace with fresh batteries
- Weak transmitter (controller ) battery
- Perkee with fresh hatteris
- The vehicle will 1ot nun or seems sluggish
- The signal is out of range
- Move the controller close to the Racer
- Erratic or only short-range operation
- Radio interference
- Change location of operation
- Weak transmitter battery
- Replace with fresh batteries
- Ali 4 anti-gravity wheels not turning at the same time
- Gear eligaUement living and wheels not matching up
- Return wheels to standard mode then repeat anti-gravity wheel function to correct matching
Battery Information
Battery acid leakage can cause personal injury and cause damage to the product
and surrounding property battery leakage occurs, thoroughływash any affected
skin, making sure to keep battery acid away from eyes, ears, nose, and mouth.
immediately wash anything or another surface that comes in contact with naked
battery adds. Leaking batteries may make “popping’ sounds. Always remove
replaceable batteries before disposing of the product. Dispose of batteries or
products with nonHeplcetde batteries according to Local State or Federal
Battery and Receding Laws.
TO AVOD BATTERY PROBLEMS
- NEVER mix oHad new batteries or different brands of batteries
- NEVER mix alkaline, standard (carbonic, rechargeable batteries with this product
- NEVER dispose of batteries in fire, as they may kak and explode.
- ALWAYS remove batteries when exhausted or unused for a long time.
- ALWAYS have an adult install battery consistent with installation instructions
- ONLYuse batteries specified by the manufacture
- Batteries are to be inserted with the correct Parity(+ and-.
- The supply terminal is not to be shortcircuited.
- Non-rechargeable batteries are not to be recharged
- Rechargeable batteries are to be removed from the toy before being charged
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>