HAMRON 604-149 230 V 12 V Transformer Instruction Manual
- June 4, 2024
- HAMRON
Table of Contents
HAMRON 604-149 230 V 12 V Transformer
SAFETY INSTRUCTIONS
Read these instructions carefully before use!
The transformer must be placed in a location that:
- Is well lit.
- Is not exposed to direct sunlight or heat sources. For indoor use only.
- Is out of the reach of children.
- Is protected against water/moisture, oil and grease.
- Is a safe distance from flammable materials.
- Must not be placed next to products that get hot.
- The rating plate is on the underside of the appliance.
- The appliance is connected to and from the mains voltage with the plug.
- Place the transformer where it is easy to disconnect it from the mains.
TECHNICAL DATA
- Type Switched transformer
- Input voltage 220-240 V
- Input current 0.6 A
- Output current 6 A
- Output 72 W
- Output voltage 12 VDC±0.3 VDC
- Temp. range -10°C – +40°C
- Storage temperature -25°C – +80°C
- Protection rating IP20
- Frequency in 50-60 Hz
TROUBLESHOOTING
If the transformer is not working properly, this may be due to a number of reasons. The following points may help you fix any problems:
- Bad connection. Clean all contact surfaces thoroughly.
- Break in connection. Check fuses, if any. Check the cable routing.
- A fuse has tripped. Check the transformer fuses. They are on the circuit board. Replace blown fuses with fuses that have the same rating.
- Overloading causes reduced power output.
- Overheating causes reduced power output. In the event of heavy loads over long periods, the transformer reduces output power to prevent temperature-related damage. If this happens:
- Switch off the transformer.
- Reduce the load, i.e. disconnect one or more of the connected devices, or wait until the transformer has cooled.
- Switch on the transformer.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>