George Kovacs Floating Oval Outdoor LED Wall Light Installation Guide
- June 9, 2024
- GEORGE KOVACS
Table of Contents
George Kovacs Floating Oval Outdoor LED Wall Light Installation Guide
ASSEMBLING THE FIXTURE (Fig.1)
- Shut off power at the fuse box or circuit breaker. If necessary, remove the old fixture including the mounting hardware.
- Carefully remove the fixture from the carton and check that all parts are included as show in Figure 1.
- Attach mounting plate (A) to the junction box with junction box screws (C) (size:8-32*1/2”L) provided. The side of the mounting plate marked “GND” must face out.
CONNECTION THE WIRES (Fig. 2)
- Connect the electrical wires as shown in Fig.2, making sure that all wire nuts are secured. If your outlet has a ground wire (green or bare copper), connect the fixture’s ground Wire to it. Otherwise, connect the fixture’s ground wire directly to the mounting plate using the green screw (B) provided. Tuck the wire connections neatly into the junction box
FINISHING THE INSTALLATION (Fig. 1)
- Loosen screws (L),remove frame(J)，Align fixture (D) onto mounting plate (A) and secure with screws (F) and rubber washers (E).
- Place glass(G) onto the fixture (D), and secure with screw (H) and plastic washer (I)
- To prevent moisture from entering the outlet box and causing a short circuit, use clear caulking (i.e. Indoor/Outdoor silicone sealant) to outline the outside of fixture back plate where it meets the wall leaving a space at bottom to allow moisture a means to escape (Fig.3).
- Place frame(J) onto the fixture (D), and secure with screw (L) Your installation
CAUTION /ATTENTION: When handling the fixture, do not apply pressure to the LEDs. Hold the fixture by the base or back plate (D) only.
Replacing LED module (Fig.4) The LED module can be replaced by a qualified
electrician without cutting of wire and without damage to any decorative
element to which the fixture is attached. See installation steps for more
details (Fig.4)
Warning: Turn off power at the circuit breaker before replacing LED module. a.
To remove the fixture from the wall, loosen screws (L),remove frame(J); loosen
screws (H),remove rubber washers (I) and
glass(G); loosen screws (F),remove rubber washers (E). Disconnect the wire
connectors and place the fixture on a clear flat surface. (Fig.1)
b. Loosen screws (X) remove the protective case(S).
c. Remove the waterproof silicon on the protective case
(S),Loosen screws (R) remove cap (Q) , Loosen screws (P) remove cap (O)and
glass plate (W).
d. Loosen screws (V), rubber washers (U), screw (M) and wire fastener (N).
Carefully remove LED module (T).
e. Reverse steps a-d for installing the new LED module..
Note: The LED module should be provided by a specified supplier.
IMPORTANT: Fixture should be installed by a qualified electrician to ensure
proper wiring and installation.
Dimmable with ELV and/or LED compatible wall dimmer switches.
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>