anslut 018965 Outdoor Luminaire Instruction Manual
- June 4, 2024
- anslut
Table of Contents
anslut 018965 Outdoor Luminaire Instruction Manual
SAFETY INSTRUCTIONS
- Only intended for outdoor use.
- The lamp must only be installed by an authorised electrician.
- The patio lamp is only intended to be used outdoors.
- The lamp must be mounted on a fireproof surface and for permanent use. It is not intended to be used as a portable lamp.
- Make sure that no one is underneath the lamp when installing it.
- The lamp must only be used intact, with the lamp glass in place.
- The lamp can get very hot when in use. Make sure that it is not possible to touch the lamp housing by mistake, and that the lamp has cooled before handling it.
- Before using the lamp for the first time it should be checked by an electrician.
- Disconnect the lamp from the mains supply before repairs or maintenance.
- The light source cannot be replaced. If it stops working, the entire lamp must be discarded.
- The lamp should be installed by an authorised electrician.
- To avoid accidents in public places, take local regulations and safety instructions/warnings into consideration.
- Only use an approved cable to connect the lamp to the mains. The external cable must as a minimum comply with the requirements for cable type H05RN-F in terms of its mechanical and electrical properties, and the wires must have a cross-sectional area of at least 1.0 mm².
WARNING!
New installations and extensions to existing systems should always be carried out by an authorised electrician. If you have the necessary experience and knowledge (otherwise contact an electrician), you can replace power switches and wall sockets, fit plugs, extension cords and light sockets. Incorrect installation can result in fatal injury and the risk of fire.
Symbols
|
Read the instructions.
---|---
| Installed at least 1 metre from the surfaces to be illuminated.
| ****
Risk of electric shock.
| Replace the lamp glass if cracked.
| Approved as per applicable directives.
****| Recycle discarded product in accordance with local regulations.
TECHNICAL DATA
| Output | 50 W |
|---|---|
| Luminous flux | 6000 lm |
| Colour temperature | 5500 K |
| Life span | 30000 h |
| Diffusion angle | 130° |
| Size | L50 x W21 x H8 cm |
- Open the junction The lid is held in place with 6 screws.
- Insert the mains cable through the cable
- Connect the wires to the terminal block as follows:
- Check that the gasket in the junction box is correctly place in the slot in the lid.
- Fasten the lid with the 6 screws.
Notes
The lamp should be installed by an authorised electrician
-
REMOVING THE LED MODULE
-
Remove the four screws on the front.
FIG.
FIG. 2 -
Remove the four screws holding the LED module.
FIG. 3 -
Cut the wire to the LED module.
-
Remove the LED module.
FIG. 4
Documents / Resources
|
anslut 018965 Outdoor
Luminaire
[pdf] Instruction Manual
018965, Outdoor Luminaire, 018965 Outdoor Luminaire, Luminaire
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>