CERBERUS PYROTRONICS FM-200 Extinguishing Systems Flexible Discharge Hose Owner’s Manual
- June 9, 2024
- CERBERUS PYROTRONICS
Table of Contents
CERBERUS PYROTRONICS FM-200 Extinguishing Systems Flexible Discharge Hose
Owner
Features
- Enhances Cylinder to Pipe Connections
- Wire Braid Reinforced
- Low Restriction to Flow
- Listed, Pending
- FM Approved, Pending
Description
The FM-200TM System Flexible Discharge Hoses are used to facilitate connections between cylinder valves and system manifold or piping. They minimize the effects of variations in the height of cylinder valve outlets due to dimension tolerances necessary in cylinder manufacture, and due to floor irregularities. Flexible Discharge Hoses are provided in 1½, 2 and 2½ inch sizes. All flexible discharge hoses are Unified Thread (flare type) on the valve end and Male NPT on the system side. A Valve Outlet Adapter must be used to connect to system piping if a flexible discharge hose is not used.
Architect Specifications
The Flexible Discharge Hoses shall be of the same pipe size as the cylinder valves which they serve. They shall be wirereinforced, have a minimum working pressure of 560 psi, and a minimum burst pressure of 2,250 psi. They shall be marked with the Cerberus Pyrotronics part number and shall be UL listed and FM approved.
Ordering Information
Part No. Description Shipping Weight
Lbs. Kg.
- 500-283898 1 ½” comes 24 inches 4.4 2.0
- 500-283899 2″ comes 31 inches 6.0 2.72
- 500-283900 2 ½” comes 48 inches 14.6 6.62
Cerberus Pyrotronics
- 8 Ridgedale Avenue
- Cedar Knolls, NJ 07927
- Tel: 201-267-1300
- FAX: 201-397-7008
Cerberus Pyrotronics
- 50 East Pearce Street
- Richmond Hill, Ontario
- L4B, 1B7 CN
- Tel: 905-764-8384
- FAX: 905-731-9182