Vidonn T1 Wireless Earbuds Instruction Manual
- June 9, 2024
- Vidonn
Table of Contents
Vidonn T1 Wireless Earbuds
Please read the instructions before use
Connect
-
Take out the earbuds (Earbuds auto power on)
-
After open the phone Bluetooth, Click the to Pairing
Reset
If earbuds has any connection or function problems, please reset the earbuds
- Delete the BT pairing information on the phone.
- Put the earbuds into the charging case to charge.
- Take out the earbuds and wait for 20 seconds. (If the above operation does not work, please try again)
Operation
| | | | | |
---|---|---|---|---|---|---
Answer/Hang up| Switch Song| Adjust Volume| Power on/ When
no connected）| Answer/Hang up| Reject Call|
Voice Assistant
X1: Click Once
X2 : Click 2 times
2S : Press and hold for 2 seconds
① Can be connected but there is no sound: Click the right earbuds to increase
the volume.
② One of earbuds cannot be charge: Clean the charging contact of the earbuds
and the charging case.
③ One of the earbuds cannot be connected: Reset the earbuds.
If the earbuds cannot be charged, please activate the warranty and contact us to send a new product.
Please clean the charging contacts of the
earbuds and charging case frequently to avoid charging failures.
Safety Instructions
- environments, it will damage the battery and circuit.
- Avoid liquid immersion into the product.
- Do not disassemble the product.
- Do not use concentrated chemical products or detergents to clean the product.
- Use only 5V/1A power supply. Connecting the power supply voltage too high may cause serious damage.
- Do not randomly discard or place the product near re or high temperature to avoid the danger of explosion.
e Vat aster Consulting GmbH Bettinastr. 30,60325 Frankfurt am Main, Germany Contact@evatmaster.com
EVATOST CONSULTING LTD Suite 11, First Floor, Moy Road, Business Centre, Taffs Well, Cardiff, Wales, CF15 7QR Contact@evatmaster.com
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
IC Caution:
This device complies with Industry Canada license -exempt RSS standard(s).Operation is subject to the following two conditions:
- This device may not cause interference, and
- This device must accept any interference, including interference that may cause undesired operation of the device.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>