SPORT-THIEME 3235805 Water Slide Instruction Manual
- June 9, 2024
- SPORT-THIEME
Table of Contents
SPORT-THIEME 3235805 Water Slide
Thank you for choosing a Sport-Thieme product!
Please read the instructions fully before use so you can enjoy the product
safely, and keep this manual for future reference.
We are always happy to answer any queries.
Product description
Intended use:
This product must only be used for its intended purpose. Misuse of any kind will compromise safety and render the warranty void!
The Sport-Thieme water slide is suitable for individuals aged 5 or over, for sliding in a seated position without the use of additional equipment. It must not be used by more than one person at a time.
The Sport-Thieme water slide is designed for swimming pools and is suitable for use in places with a moderate climate, i.e. average daily air temperatures between -20°C and +35°C. EN 1069 requirements and, in particular, part two of the standard, must be met.
For correct use, the manufacturer recommends a water level of 300 mm.
Dimensions (H×L): 2,150×4,000 mm
Weight: 50 kg
Platform height: 1,500 mm
Slide incline: ≤ 70%
Slide length: 1,900 mm
Recommended flow rate of the slide’s water jet: 0.18 m³/h
Caution!
- This product should only be used in public areas under supervision.
- To be used only under direct adult supervision.
- Not suitable for children under 3.
- Please ensure adequate fall protection.
- Do not overload or climb on this product.
- Danger of tipping over if handled incorrectly.
- Contact with chemicals, especially acids, must be avoided at all costs!
- Sharp edges can damage the surface.
Modification of products
Modifications of any kind will compromise safety and render the warranty void!
Assembly
Preparing the installation site
The manufacturer recommends preparing a foundation pit with a dimension of 3,000×4,000×400 mm. Fill the bottom of the pit with compacted, crushed stone to a level of 100 mm. It is essential to pour the concrete using reinforced steel mesh. When preparing the installation site and planning its location, please take into account that the slide should be facing a north-easterly direction or be partially in the shade of trees, as its surface may get too hot otherwise.
Foundation
The Sport-Thieme water slide is to be installed on a concrete foundation with the water basin being at least 300 mm deep and 1,500 mm wide to either side of the slide’s exit point. Once the slide has been assembled, it should be mounted to the foundation. The manufacturer recommends using high-performance (hot-dip galvanised) HSA-F wedge anchors (M12×137) for everyday static loads in uncracked concrete.
Parts list
- 1 ladder
- 1 slide
- 1 safety tube 20/2/530 mm (attached to slide)
- 2 handrails, 20/2/80 mm tubing
- 2 handrails, 20/2/40 mm tubing
- 6 anchor bolts, 10×100
- 16 lens head bolts, 10×25
- 26 washers, 10×35
- 4 safety cap nuts, М10
- 1 H400 support (attached to slide)
- 18 safety nuts with teflon ring, M10
- 3.6 m non-slip strip, 25×360 (attached to slide)
- 2 connectors for D16mm hose (attached to slide)
Assembling the slide
Step 1
Connect the two parts of the slide using the bolts supplied.
Step 2
Place the two handrails in the holes provided and fasten with the
corresponding washers and nuts.
Step 3
Set the slide up at its intended location and attach it to the foundation
using the bolt anchors.
Step 4
Attach the water hoses to the clamps on either side below the handrails. The
existing connection has a diameter of 16 mm. The hose must therefore be
slightly larger.
Transportation and packaging
For easy and safe transportation, the slide has been disassembled with the upper handrails of the ladder also disassembled and included. The slide comes in two boxes: the slide and ladder are packed separately with polyethylene, five-layer corrugated cardboard and wrapped in film.
Please note:
Do not compromise the integrity of the packaging during transportation and
loading.
The product has to be secured and/or tied down so that it will not move during
transport.
Storage
- Do not damage the packaging.
- Do only store the slide in its original packaging.
- Store the slide in a dry environment at temperatures between +5°C and +25°C.
- Do not store for more than six months.
Maintenance and care
Information regarding regular inspection:
- Perform a visual check at regular intervals.
- We invest in continuous quality control of our products, which means technical updates may lead to minor changes to the instructions.
- Check the tightness of the bolt connections regularly.
- Check the product for any damage and replace worn parts.
Once a week:
- Inspect the equipment and its safety zone for cleanliness and remove any unwanted items.
- Check water connections and nozzles for damage and blockage.
Four times per year:
- Remove cracks, wood chips and broken edges.
Twice per year:
- Check that the equipment (e.g. vertical supports, columns, platforms, etc.) is intact and retighten the screw connections if required.
- Check other components of the slide for wear and stability. If necessary, tighten connections and replace defective parts.
- Check slide surface for cleanliness, remove protruding parts, replace damaged slide or components.
- Check the foundation and supporting structure of the equipment for corrosion and deformation. Adjust, repair and replace if necessary.
Should you have any questions, we are happy to help.
Your Sport-Thieme team
Documents / Resources
|
SPORT-THIEME 3235805 Water
Slide
[pdf] Instruction Manual
3235805, 3235805 Water Slide, Water Slide, Slide
---|---