SPORT-THIEME 306 8159 Ballet Barre Wall Bracket Instruction Manual
- June 9, 2024
- SPORT-THIEME
Table of Contents
38367 Grasleben – Tel. 05357 – 181 81
www.sport-thieme.de
Operating/assembly instructions
Sport-Thieme ballet barre wall bracket
Prod. no.: 306 8159 – single
306 8146 – double
Assembly instructions for ballet barre wall bracket
Thank you very much for choosing a Sport-Thieme product. Please read the instructions fully before you assemble the equipment so you can enjoy the product and its guaranteed safety:
1. When you open the package, please ensure all the necessary parts are included.
- 1 wall bracket for ballet barre (single or double)
- 2 screws 8 x 80
- 2 washers 8
- 2 or 4 spax screws 5 x 25
- 2 nylon wall plugs 10
- ballet barre, round (not included)
Assembly instructions
Before you begin assembly, please ensure that you mount the ballet barre
bracket① to a solid and stable wall (no plasterboard, hollow bricks or
similar)! Determine the required height for fixing the barre⑥. Follow ill. 2
to mark the drilling holes starting from that height. Make sure that all
brackets① you wish to mount are level.
Using a suitable masonry drill bit, drill the holes and put in the wall plugs.
Now, insert the two screws② with washers③ through the wall bracket’s holes①
and tighten them with a hex key into the wall plugs⑤.
Finally, connect the wall bracket① and the ballet barre⑥ using the spax screws
included④.
In order to prevent possible chipping, the ballet barre can be pre-drilled
with a 2 mm wood drill bit.
Individually choose the distance between the round ballet barre brackets①
according to your needs and depending on the respective ballet barre⑥.
The distance between the brackets should not exceed 1.50 m.
Ill. 2: Drilling plan for ballet barre wall bracket single and double
Caution: Do not overload or climb the equipment! Maximum load 50 kg
Maintenance and care instructions
Instructions:
Carry out a visual check at regular intervals. Due to our continuous
quality control of the products, technical changes may occur which may lead to
slight deviations in the instructions.
Check at regular intervals that the screw connections are tight.
Check the equipment for possible damage and replace worn-out parts.
We are happy to answer any questions you may have.
Your Sport-Thieme Team