Hamron 016049 LED Light Bar Instruction Manual
- June 4, 2024
- HAMRON
Table of Contents
Hamron 016049 LED Light Bar Instruction Manual
OPERATING INSTRUCTIONS
Important! Read the user instructions carefully before use. Save them for future reference. (Translation of the original in- structions)
Care for the environment!
Recycle discarded product in accordance with local regulations.
JULA AB, BOX 363, 5E-532 24 SKARA
2022-01-26
© Jula AB
SAFETY INSTRUCTIONS
- Read these instructions carefully before installation and save them for future reference.
- Always comply with the applicable laws and regulations for the installation and use of auxiliary headlights.
SYMBOLS
TECHNICAL DATA
DESCRIPTION
- Bottom fastener
- Side fastener
FIG.1
INSTALLATION
- Drill screw holes with a diameter of 8.5 mm in the surface where the product is to be installed.
- Put the screws in the holes, put on the lock washers and tighten the nuts.
- The product can be mounted with side or bottom fastener.
- Cable colour coding: red wire is (+), black wire is (—).
WARNING!
- The product must only be used within its rated voltage range, 12 to 24 VDC.
- The light source gets hot when the product is switched on. Allow the light source to cool for at least 30 minutes before touching or handling it.
- Make sure there is a free flow of air through the cooling fins on the light source and keep the fins clean.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>