GEORGE KOVACS P1259-143-L Wall Mount Outdoor Fixture Instruction Manual
- June 9, 2024
- GEORGE KOVACS
Table of Contents
GEORGE KOVACS P1259-143-L Wall Mount Outdoor Fixture
WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
AVERTISSEMENT: COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DO DISJONCTEUR
PREPARATION
-
Shut off power at the fuse box or circuit breaker box. If necessary remove the old fixture and mounting hardware.
-
Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to lose any small parts necessary for installation.
MOUNTING THE FIXTURE
-
Secure mounting back plate (D) to junction box (A) using junction boxes screws (E) (Size: 8-32* l/2″‘L). The side of the mounting back plate marked “GND” must face out.
CONNECTING THE WIRES
-
At this point, connect the electrical wires as shown in Fig. 2, making sure that all wire connectors are secured. If your outlet has a ground wire (green or bare copper), connect the fixtures ground wire to it. Otherwise, connect the fixture ground wire directly to the back plate (D) using the green screw provided. After wires are connected, tuck them carefully inside the junction box.
FINISHING THE INSTALLATION -
.Place the fixture’s back plate (H) over the mounting back plate (D) and secure with washers (F), screws (G).
CAUTION /ATTENTION : When handling the fixture, do not apply pressure to the glass. Hold the fixture by the base.
Replacing LED module
The LED module can be replaced by a
qualified electrician without cutting of wire and without damage to any
decorative element to which the fixture is attached. See installation steps
for more details
- Shut off power at circuit breaker, remove screws (G) and washers (F) to dismount the back plate.
- Remove screws (J) to dismount the glass PG1251 (N) and diffuser (M)
- Remove the screws (L) on LED module.
- Carefully disconnect the LED module (K) from the heat sink.
- Reverse steps a-d for installing the new LED module.
Note: The LED module should be provided by a specified supplier.
IMPORTANT: Fixture should be installed by a qualified electrician to
ensure proper wiring and installation.
Dimmable with ELV and/or LED compatible wall dimmer switches.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>