GEORGE KOVACS P5044-X-L Tube LED Bath Vanity Light Instruction Manual
- June 9, 2024
- GEORGE KOVACS
Table of Contents
GEORGE KOVACS P5044-X-L Tube LED Bath Vanity Light
INSTALLATION INSTRUCTIONS FOR P5044-X-L
For Wall Mount Fixture
WARNING ! SHUT POWER OF FAT FUSE OR CIRCUIT BREAKER .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU
DISJONCTEUR.
PREPARATION
- Shut off power at the fuse box or circuit breaker box. If necessary. Remove the old fixture and mounting hardware.
- Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to lose any small parts necessary for installation.
MOUNTING THE FIXTURE (FIG. 1)
- Secure mounting plate (A) to the outlet box using junction box screws (B) (Size: 8-32*1/2”L). The side of the mounting plate marked “GND” must face out.
CONNECTING THE WIRES (FIG. 2)
- At this point, connect the electrical wires as shown in Fig. 2, making sure that all wire connectors are secured. If your outlet has a ground wire (green or bare copper), connect the fixtures ground wire to it. Otherwise, connect the fixture ground wire directly to the mounting plate (A) using the green screw provided. After wires are connected, tuck them carefully inside the junction box.
- Place the fixture’s back plate (C) over the mounting back plate (A) and secure with screws (D/SIZE： ‘M4*8MM).
FINISHING THE INSTALLATION (FIG.1)
- Slide the glass shade (H/PG5044) into the front bracket (E). While supporting the glass, attach glass holder (F) to the front bracket (E) with screws (G) to secure the glass in place.
CAUTION/ATTENTION: When handling the fixture, do not apply pressure to
the LEDs, Hold the fixture by the base or front bracket (E) only.
IMPORTANT: Fixture should be installed by a qualified electrician to
ensure proper wiring and installation. Dimmable with C-L (CFL & LED) type and
Incandescent/Halogen type dimmers
Replacing LED module (Fig. 3)
The LED module can be replaced by a qualified electrician without cutting of wire and without damage to any decorative element to which the fixture is attached. See installation steps for more details (Fig 3.)
- a. Remove screws (G) Glass holder (F) and glass shade (H).
- b. Remove the wire nuts located inside the fixture backplate to disconnect the LED module.
- c. Remove screws (N) on bracket (E). Carefully remove the LED module (I) from bracket (E),
- d. Reverse steps a-c for installing the new LED module.
- e. Note: The LED module should be provided by a specified supplier.
- f. For better heat dissipation the LED module (I) should be applied with thermal grease when re-lamping.
Brand : Lutron
Brand : Leviton / Model number : Sureslide 6615
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>