PETKIT K2 Air MagiCube Smart Odor Eliminator User Manual

: June 9, 2024
: PETKIT

PETKIT K2 Air MagiCube Smart Odor Eliminator User Manual

Introduction

Thank you for purchasing PETKIT K2, smart odour eliminator.
Please read this user manual carefully before using.
Once the product is installed or used, it indicates that you have carefully read and accept the safety instructions below.
Our company will neither assume any responsibility nor undertake any legal liabilities for any accidents and damages caused due to violations.
The company reserves the right of explanation and revision for the terms.

Safety Instructions

Failure to comply with the following clauses may lead to that the product cannot be normally used or occurrence of other accidental losses.

Please use it indoors.
Please use the original power adapter and PETKIT Concentrated Air Purifying Refill.
Please install and use device in strict accordance with the manual.
In case of problems with using the product, please contact the customer service

Package Contents

Package Content | | | |
---|---|---|---|---
Mainframe cover ×1| Water barrel ×1| Concentrated Air Purifying Refill ×1| Power Adapter ×1| Manual ×1

Product Introduction

Exterior appearance

Note: We will carry out regular product improvement in order to provide better products.
When the product picture is slightly different from the actual product, the actual product shall prevail.

Mainframe cover (interior)

Filter screen in the mainframe cover

Water barrel

About Control Panel

Control Panel

Note: Switch between °C and °F in the PETKIT app.
Note: In case when the content is hotter than 100 °F, only the last two digits will be displayed.

Key Functions

Functions	Operation
On / Off	Press the function key for a few seconds when the keys are

unlocked.
Switch mode| Click the function key when the keys are unlocked.
Enable locking| Automatic locking after double-clicking the locking key or if there was no input in five seconds.
Unlock| Double click the lock key.
Start network pairing, the Wi-Fi indicator flickers and the Bluetooth is enabled| Press the function key and the lock key at the same time for a few seconds when the keys are unlocked.

Mode Introduction

Quick Guide

Place the product in a right position.
To better exert the performance of AIR MAGICUBE, a certain distance (no less than 10 centimeters) between air inlet and the shelter
(such as wall) shall be kept in use. Considering different pet habits, it shall be placed in the position where the pet cannot reach it.
Using Instruction

Add the concentrated air purifying refill.
Add enough water to reach the water level mark and pour the whole PETKIT concentrated air purifying refill to the water barrel. Specifically, a solution of nine parts water to one part mixture should be formed.

Complete the installation.
Align the mainframe cover with the water barrel, then press down.

Switching on.
Connect the power adapter. After switching on for the first time, the device will enter the default mode (AUTO mode); or switch the mode by short pressing the function key. (Refer to Key Functions for the detailed description of key use.)
Using Instruction

App Access

After powering on, observe the Wi-Fi indicator light state.
If the indicator light flickers, it means the device entered the network pairing mode.
Note: In case of network change, press function key with lock key at the same time for a couple of seconds under the state of unlocking, until the Wi- Fi indicator light flickers, and then start network pairing again.

Download and open “PETKIT” app to enter the home page of the app, click “+” to add a new device and select the device that should be added.
App Access

Connect the device with the network.
You can use the help of a video by clicking “Watch video”.

Cleaning and Maintenance

Before thorough cleaning of the device, please turn off the power supply and unplug the power adapter.

Cleaning the cover

Remove the upper cover.

Pull out the filter screen at the bottom of the cover.
There should be no water in the remaining parts of the cover.

Tips for taking down the filter screen:
Pull out the white periphery of the cover outward with left hand and pinch the grey handle of the filter screen with right hand thumb for lifting upward, as shown in the picture.

The filter screen should be rinsed with flowing clear water or ordinary cleaner.
Brush and sponge from the PETKIT Cleaning Kit can be used for cleaning, too.

It is suggested to use a clean, soft cloth for scrubbing or brush and sponge from the PETKIT Cleaning Kit for dust removal.

Cleaning the water barrel

Pour out excess liquid in the barrel.

The barrel should be rinsed by flowing clear water or ordinary cleaner.
Do not use a chemical reagent, such as gasoline or kerosene bleach.

The water gauge and the built-in water level detector can be taken out for cleaning.

All parts included in the water gauge:
Water gauge cover, float spindle (water level detector), PE foam (water level detector)
Cleaning Instruction

Precautions for use

No water should be present in the mainframe cover.
The device should be washed and used only with cold water.
The PETKIT Concentrated Air Purifying Refill can be diluted only with normal temperature pure water.
The product shall be used together with PETKIT Concentrated Air Purifying Refill.
The purification liquid is inedible. Do not let pets to lick the liquid in the device.
Do not place the product in the place with direct sunlight, which shall be far away from combustion source.
Keep horizontal placement of the product to avoid liquid outflow or device abnormality.
After used for a long time, the educt in the barrel is the educt of PETKIT Concentrated Air Purifying Refill, which is normal.
Do not place any article on top of the device.
Do not shield the inlet/outlet or avoid foreign matter entering inlet/outlet.
The device is under the low-voltage mode, but the electric leakage will happen if the pet bite the electric wire. Correct guidance for you shall be necessary.
Do not drag the wire to avoid breakage when using, plugging and unplugging power lines.
Do not move the product when in use and cut off the power supply at the time of movement.
Do not touch the power adapter or the socket with wet hands.
The product shall be properly stored after removing the liquid in the lower barrel and unplugging the power adapter if the product isn’t going to be used for a long time.
If the device is used by a child, it shall be used under the guidance of an adult.
Except for repair personnel, nobody is allowed to repair the product to avoid various accidental damages.

Parameters

Product name	Air Magicube Smart Odour Eliminator
Product model	P9201
Dimensions	180 mm × 180 mm × 213 mm
Total weight	1.15 kg (including adapter)
Rated voltage	6V DC
Rated power	6W

PETKIT Concentrated Air Purifying Refill

The product shall be used together with PETKIT concentrated purification liquid which filtering performance is different based on actual environment

The PETKIT concentrated purification liquid is a concentrated liquid which can be used after being diluted as per the proportion – 1:9, as instructed above.
The following data comes from a third-party detection institution.
- Under the experimental conditions, the product reaches the actual nontoxic grade after acute oral toxicity test according to Version 2002 standard of disinfection technology standard.
  It is of actual non-toxic grade after acute inhalation toxicity test.
- Under the experimental conditions, the inhibition ratio against Escherichia coli, staphylococcus aureus and candida albicans of the product is >99% pursuant to GB 15979-2002 standard.
- Under the experimental conditions, the inhibition ratio against common germs (such as aspergillus niger, malassezia furfur, salmonella typhimurium and klebsiella pneumoniae) of the product is >99% in line with QB/T 2738-2012 standard.
- Under the experimental conditions, the bacteriostatic rate against staphylococcus albus of the product in the interior space reaches to 77% as per GB 21551.3-2010 standard.
- Under the experimental conditions, the removal efficiency of the product against common indoor pollutants (including ammonia, hydrogen supplied and formaldehyde) is >80% pursuant to QB/T 2761-2006 standard.

Note: Aroma concentration and duration are different on account of difference in space environment, use pattern and frequency.

Warranty Conditions

A new product purchased in the Alza.cz sales network is guaranteed for 2 years.
If you need repair or other services during the warranty period, contact the product seller directly, you must provide the original proof of purchase with the date of purchase.
The following are considered to be a conflict with the warranty conditions, for which the claimed claim may not be recognized:

Using the product for any purpose other than that for which the product is intended or failing to follow the instructions for maintenance, operation, and service of the product.
Damage to the product by a natural disaster, the intervention of an unauthorized person or mechanically through the fault of the buyer (e.g., during transport, cleaning by inappropriate means, etc.).
Natural wear and aging of consumables or components during use (such as batteries, etc.).
Exposure to adverse external influences, such as sunlight and other radiation or electromagnetic fields, fluid intrusion, object intrusion, mains overvoltage, electrostatic discharge voltage (including lightning), faulty supply or input voltage and inappropriate polarity of this voltage, chemical processes such as used power supplies, etc.
If anyone has made modifications, modifications, alterations to the design or adaptation to change or extend the functions of the product compared to the purchased design or use of non-original components.

EU Declaration of Conformity

Identification data of the manufacturer’s / importer’s authorized representative:
Importer: Alza.cz a.s.
Registered office: Jankovcova 1522/53, Holešovice, 170 00 Prague 7
CIN: 27082440

Subject of the declaration:
Title: Smart Odour Eliminator
Model / Type: K2

The above product has been tested in accordance with the standard(s) used to demonstrate compliance with the essential requirements laid down in the Directive(s):
Directive No. 2014/53/EU
Directive No. 2011/65/EU as amended 2015/863/EU

WEEE

This product must not be disposed of as normal household waste in accordance with the EU Directive on Waste Electrical and Electronic Equipment (WEEE – 2012/19 / EU).
Instead, it shall be returned to the place of purchase or handed over to a public collection point for the recyclable waste.
By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. Contact your local authority or the nearest collection point for further details.
Improper disposal of this type of waste may result in fines in accordance with national regulations.

FAQ

CUSTOMER SUPPORT

Dear customer,
Thank you for purchasing our product.
Please read the following instructions carefully before first use and keep this user manual for future reference.
Pay particular attention to the safety instructions.
If you have any questions or comments about the device, please contact the customer line.

www.alza.co.uk/kontakt
+44 (0)203 514 4411
Importer: Alza.cz a.s., Jankovcova 1522/53, Holešovice, 170 00 Praha 7,
www.alza.cz

Why does the device display the lack of liquid while there is liquid in the barrel?

Pull out the water gauge in the lower barrel to inspect internal parts of the water gauge
successively: Whether the float spindle is stuck. Inspect whether the top magnet or the
bottom pearl wool of the float spindle is lost. If the lack of liquid is still displayed after
the above inspections are conducted, contact the customer service personnel.

Why does the device display that the liquid is remaining while there is no liquid in
the barrel?

Pull out the water gauge in the lower barrel and inspect whether the internal part (float
spindle) is stuck.

Why is the function key unusable?

First, inspect whether the orange indicator light of lock is on. If the orange indicator light
is on, it means the device is locked. At this time, the device cannot be used. You can
unlock the device by double clicking the lock key. The orange indicator light will be off,
and the function key can be used again after unlocking. In case of failure in unlocking or
the indicator light being unresponsive after double clicking the lock key, contact the
customer service personnel. To prevent touch errors, the lock key cannot be used
withing two seconds after unlocking.

For how long can a package of purification liquid be used approximately?

The service time of the PETKIT Concentrated Air Purifying Refill is different due to
difference in environment, use pattern and frequency. It can be used for about one
month when it is working for eight hours per day under the powerful mode (refer to
reminder for lack of liquid)

Why can’t I switch between Fahrenheit degree and degree centigrade?

The switch between Fahrenheit degree and degree centigrade can be done in the PETKIT
app only.

Is there any colloidal or crystalline solid in the barrel after a long time of use?

The colloidal or crystalline solid in the barrel is educt of the PETKIT Concentrated Air
Purifying Refill after a long period of use, which is normal.