ACURITE 00797SBDI Solar Window Thermometer Instruction Manual

: June 9, 2024
: Acurite

Table of Contents

Instruction Manual
Solar Window Thermometer
- model 00797/ 00797SBDI
- SETUP
References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)

Instruction Manual

Solar Window Thermometer

model 00797/ 00797SBDI

Questions? We’re here to help!
Visit us online at www. acurite.com/support

SAVE THIS MANUAL FOR FUTURE REFERENCE.

SETUP

Features & Benefits

BACK OF THERMOMETER

Solar Panel
To extend battery life.
Clock
Current Temperature
High Temperature Record
Highest temperature recorded over past 24 hours.
Low Temperature Record
Lowest temperature recorded over past 24 hours.
SET Button
For clock setup.
UP Button
Press to select between Fahrenheit and Celsius, and for clock setup.
Suction Cup Mount
Easily mount on a window.

Power On

This thermometer includes a “CR-2032” battery that is already installed. Remove the plastic insulator tab to activate the battery and thermometer display.
NOTE: The initial temperature reading may be higher than the actual temperature due to the heat from your hands warming up the case.

Placement

For the most accurate temperature readings, place your thermometer in a location that is OUT OF DIRECT SUNLIGHT. This unit can be mounted on a window using the included suction cup. For the best performance, clean the area where you want to adhere the thermometer.
Moisten the suction cup and then press it evenly onto the clean surface.
Occasionally, suction cups will not adhere well in very cold temperatures. In this case, it may be necessary to re-apply the suction cup.

Replace the Battery

Open top cover, follow the polarity (+/–) diagram in the battery compartment.

Remove and safely discard the old battery (see disposal safety info included).
Insert a new “CR-2032” battery, paying close attention to the polarity markings.

WARNING: THIS PRODUCT CONTAINS A BUTTON-CELL BATTERY. IF SWALLOWED, IT COULD CAUSE SEVERE INJURY OR DEATH IN JUST 2 HOURS. SEEK MEDICAL ATTENTION IMMEDIATELY IF INGESTED.

Set the Time

Open top cover. Press and release the “SET” button to choose between a 12 or 24 hour clock format. To set the time, press and HOLD the “SET” button until the clock hour flashes on the display. Use the “UP” button to set the time, taking note of the AM/PM indicator. Press the “SET” button to save your selection.

Select Degrees Fahrenheit or Celsius

While top cover is off, press “UP” button to select between degrees Fahrenheit (ºF) or Celsius (ºC) temperature units.

Using the Thermometer

High & Low Records

The display shows 24 hour high & low temperature records. To manually reset the high/low records currently being viewed, press and hold the “UP” button beneath the top cover for 3-5 seconds.

Specifications

Temperature Range:	-13°F to 122°F; -25°C to 50°C
Battery Requirements:	1 x CR-2032 (included)

FCC Information

This device complies with part 15 of FCC rules. Operation is subject to the following two conditions:
1- This device may NOT cause harmful interference, and
2- This device must accept any interference received, including interference that may cause undesired operation.
WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, There is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user authority to operate the equipment.

This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation of the device.

PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY SAFE WAY AND IN ACCORDANCE WITH YOUR LOCAL LAWS AND REGULATIONS.
BATTERY SAFETY: Clean the battery contacts and also those of the device prior to battery installation. Remove batteries from equipment which is not to be used for an extended period of time. Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead batteries from the device. Dispose of used batteries properly. Only batteries of the same or equivalent type as recommendedaretobe used. DO NOT incinerate used batteries. DO NOT dispose of batteries in fire, as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (alkaline/standard). DO NOT use rechargeable batteries. DO NOT recharge non-rechargeable batteries. DO NOT short-circuit the supply terminals.

Customer Support

AcuRite customer support is committed to providing you with best-in-class service.
For assistance, please have the model number of this product available and contact us by visiting acurite.com/support.

Limited 1-Year Warranty

AcuRite is a wholly owned subsidiary of Chaney Instrument Company. For purchases of AcuRite products, AcuRite provides the benefits and services set forth herein. For purchases of Chaney products, Chaney provides the benefits and services set forth herein.

We warrant that all products we manufacture under this warranty are of good material and workmanship and, when properly installed and operated, will be free of defects for a period of one year from the date of purchase.

Any product which, under normal use and service, is proven to breach the warranty contained herein within ONE YEAR from date of sale will, upon examination by us, and at our sole option, be repaired or replaced by us. Transportation costs and charges for returned goods shall be paid for by the purchaser. We hereby disclaim all responsibility for such transportation costs and charges. This warranty will not be breached, and we will give no credit for products which have received normal wear and tear not affecting the functionality of the product, been damaged (including by acts of nature), tampered, abused, improperly installed, or repaired or altered by others than our authorized representatives.

Remedy for breach of this warranty is limited to repair or replacement of the defective item(s). If we determine that repair or replacement is not feasible, we may, at our option, refund the amount of the original purchase price.

THE ABOVE-DESCRIBED WARRANTY IS THE SOLE WARRANTY FOR THE PRODUCTS AND IS EXPRESSLY IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED. ALL OTHER WARRANTIES OTHER THAN THE EXPRESS WARRANTY SET FORTH HEREIN ARE HEREBY EXPRESSLY DISCLAIMED, INCLUDING WITHOUT LIMITATION THE IMPLIED WARRANTY OF MERCHANTABILITY AND THE IMPLIED WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE.

We expressly disclaim all liability for special, consequential, or incidental damages, whether arising in tort or by contract from any breach of this warranty. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you.

We further disclaim liability from personal injury relating to our products to the extent permitted by law. By acceptance of any of our products, the purchaser assumes all liability for the consequences arising from their use or misuse. No person, firm or corporation is authorized to bind us to any other obligation or liability in connection with the sale of our products. Furthermore, no person, firm or corporation is authorized to modify or waive the terms of this warranty unless done in writing and signed by a duly authorized agent of ours.

In no case shall our liability for any claim relating to our products, your purchase or your use thereof, exceed the original purchase price paid for the product.

Applicability of Policy

This Return, Refund, and Warranty Policy applies only to purchases made in the United States and Canada. For purchases made in a country other than the United States or Canada, please consult the policies applicable to the country in which you made your purchase.

Additionally, this Policy applies only to the original purchaser of our products. We cannot and do not offer any return, refund, or warranty services if you buy products used or from resale sites such as eBay or Craigslist.

Governing Law

This Return, Refund, and Warranty Policy is governed by the laws of the United States and the State of Wisconsin. Any dispute relating to this Policy shall be brought exclusively in the federal or State courts having jurisdiction in Walworth County, Wisconsin; and purchaser consents to jurisdiction within the State of Wisconsin.

www. AcuRite.com

Printed in China
00797 INST 110822

© Chaney Instrument Co. All rights reserved. AcuRite is a registered trademark of the Chaney Instrument Co., Lake Geneva, WI 53147. All other trademarks and copyrights are the property of their respective owners. AcuRite uses patented technology. Visit www.AcuRite.com/patents for details.