Bluestone MC17 Car Mount Vent Clip User Manual

: June 5, 2024
: Bluestone

Table of Contents

INTRODUCTION
PACKAGE CONTENTS
PRODUCT OVERVIEW
SPECIFICATIONS & FEATURES
HOW TO USE
CARE AND SAFETY
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Bluestone MC17 Car Mount Vent Clip

Product Features

INTRODUCTION

Vent Clip Car Mount is the last mount you’ll need to purchase. The sleek black design ensures that it matches with every dashboard and car environment it is put into. It can be angled in all different types of directions so you could place it and use it however you would like. The vent clip is super easy to install onto any vent and ensures its easy for relocating if needed.
There is multiple areas on the mount that have a foam like padding to ensure its shock proof abilities.

PACKAGE CONTENTS

1 x Mount Body
1 x Socket
1 x Vent Clip
1 x Tri pronged piece with ball at end

PRODUCT OVERVIEW

SPECIFICATIONS & FEATURES

Mount is approx 11 cm h x 6.5cm w x 13cm depth when fully assembled.
Wing Span is 11 cm when fully expanded.
Feet are 4cm wide.
Strong and Secure Vent clip.
Shockproof Design.
360° rotating phone bracket.
Easy Installation.
Tight Fitting Clamp with Rubber Grips.
Quick-Use Spring Loaded Clamping Mechanism.

HOW TO USE

Constructing the Mount

Un box all pieces and make sure you have everything.
Take the mount and the 3 pronged piece with the ball.
Screw joint part onto the back of the square but loosely.
Leaving it loose will allow for the ball to pop in easily.
Once the ball is in socket, tighten knob and make sure its tight.
Next you’re going to take the vent clip part and hold it towards the back.
Push very hard to click it into the 3 pronged star piece.
Make sure that the spring side it up towards the sky.
Next you’re going to hold the mount up the vent and pull back on the loaded spring and wedge it in there and let go.
Then you’re going to press the wing pressure button on the side to allow the wings to expand to put your phone inside.
Make sure the phone is touching the feet padding to make sure it is secure and can embrace the strong bumps.
Next you’re going to close the wings so that there tight against the phone, push in as much as you can until it cant click anymore.
To remove the phone from the mount, just press the wing pressure button again and it will open up and release phone!

CARE AND SAFETY

Do not use this unit for anything other than its intended use.
Keep the unit away from heat source, direct sunlight, humidity, water or any other liquid.
Do not expose the device to extremely high or low temperatures, as it may damage the battery.
Do not operate the unit if it has been wet or moist to prevent against electric shock and/or injury to yourself and damage to the unit.
Do not use the unit if it has been dropped or damaged in any way.
Repairs to electrical equipment should only be performed by a qualified electrician. Improper repairs may place the user at serious risk.
Keep the unit out of reach of children.
This unit is not a toy.