BATAVIA BT-SG001 Multi Fitness System SpaceGym Instruction Manual

: June 9, 2024
: BATAVIA

BATAVIA BT-SG001 Multi Fitness System SpaceGym Instruction Manual

Overview

Handle
Spool
Release
Footpad
Deck
Bumper
Cord
Base
Starter disc

Explanation of the symbols

The following symbols are used in the user manual or on the product:

Note Icon Warning!
To reduce the risk of injury, the user must read the instruction manual.

Denotes risk of personal injury, loss of life or damage to the tool in case of non-observance of the instructions in this manual.

Safety instructions for hometrainers

Space Gym is ready to use out of the box.
Read instructions carefully before use.
Do not use if any of the parts are missing or damaged. Visit our website for help and returns information.
If you have any doubts about your ability to exercise safely, please consult your doctor before using Space Gym.
Space Gym is not a toy.
Children under 8 years and pets should be kept away from Space Gym.
Keep all packaging away from children and recycle responsibly.
To ensure optimum performance always use original Space Gym spare parts.
Always use Space Gym on a smooth level floor.
Wear suitable workout clothing, sweat bands and non-slip training shoes.

Setting up and getting started

Place Space Gym on a hard, flat surface.
Stand on the textured footpads (4) on the deck (See Fig. A).
Lift the handle (1) and pull the cord fully out (See Chapter 4).
Adjust to the top height of your next exercise.
Turn the starter disc (9) to draw the cord in ( See Fig. B).
Pull and release handle to spin-up flywheel disc (See Chapter 6).
Make smooth extension and return strokes (See Chapter 5).
Keep cord straight as the handle rises and returns (See Chapter 4).

Adjusting Cord Length (See Fig. C)

Pull handle until the flywheel stops.
Adjust cord length to upper exercise limit.
Press button and pull to add 3cm cord length to upper exercise limit.
Add 3cm to each exercise top extension.

Retract cord (See Fig. D) Twist spool clock-wise to shorten cord.
Extend cord (See Fig. E) Push button to extend cord and pull.
Setup Instruction

Starting the flywheel disc

Using your foot, the start disc in the centre of the deck turns in either direction to start the flywheel.
Every pull of the handle accelerates the flywheel to quickly reach the extents of each exercise.
A smooth, steady pull, easing off for the transition at the top of the stroke.
Gradually increase your pull and resist the pullback for maximum benefit.

Get the most out of Space Gym (See Fig. G)

Reduce the pull force in the last few centimetres of upward pull. This avoids the jerk of a sudden change in direction.
Resist pullback

Keep the cord straight at all times (See Fig. H) .

Product advice and help

Please visit our website to find exercise advice, videos and product information.
Whether you are using Space Gym for rehabilitation, everyday fitness or more intensive weight or cardio training, there are video guides and advice on how to get the most out of your new Space Gym.
Many exercises can be done on SpaceGym, each benefiting a different area and muscle set. The guide will help you decide which exercise will deliver the benefits you are looking for.
Space Gym is ideal for low stress and extreme fitness work, but if you have any pain or discomfort, take a break and / or consult a doctor or physiotherapist.

Cleaning

Clean only with a soft cloth and mild anti- bacterial detergent.
Allow to dry completely before use.
If the cord gets wet, allow to dry completely before use.
Do not immerse or allow water inside your Space Gym.
Check the flywheel screw is tight before use.

Maintenance

Check the cord is in good condition before use. Remove the flywheel to access the service hole and check the condition of the cord where it exits the central axle (See Chapter 10).
If in doubt, replace the cord, taking care to route the new cord exactly as shown in chapter 10.
Do not apply any form of lubricant to Space Gym.

Checking for cord wear

Signs of wear:

Damage to the outer fibres of the cord
Cord surface becoming hairy
Local thinning of the cord
If in doubt, replace the cord. Replacement Cord, parts and accessories: www.spacegym.club

Remove old cord. Turn spool grip to vertical. Remove rubber bumper.
Thread cord through rubber bumper, handle & spool.
Tie knot in cord. Pull knot into spool. Refit rubber bumper.
Pull cord firmly to check the knot bumper.

Fitting replacement cord- Body

Cord from handle enters via the metal eye in the deck.
Cord goes around roller 1, then internally to roller 2.
Cord then wraps around roller 2 as shown.
Insert cord through the narrow hole in central axle.
Knot the cord to secure the end. Pull cord to test knot.
Replace the flywheel disc, covering the access hole.

A: Allen key
B: Disk spacer

Troubleshooting

Flywheel not spinning free
Check there is nothing trapped under the unit. Lift the unit and check that flywheel spins freely.
Flywheel noisy function
Check that the flywheel is spinning true and the screw is tight on the washer

spacer (1 disc) (See Chapter 16)
- Cord stuck and will not pull
  Cord may be jamming. Check cord is routed as shown on Chapter 12.
- Cord sticks repeatedly
  Cord may be jamming on roller 1. Check cord is routed as shown on Chapter 12.
- No resistance from flywheel
  Flywheel could be loose or detached. Are flywheel, spacer, washer, screw in place and tight. (See Chapter 16).
- Space Gym rocks
  Check floor is flat and all six rubber feet are in place. Check for obstacles.
- Fly wheel hits floor
  Do not use on carpet or foam backed flooring. If disc is not true, re-seat disc and tighten screw. (See Chapter 16).
- Handle spool jamming
  Press release button and pull hard to free cord. Check cord is correctly fitted. (See Chapter 11)

Spares and accessories Order

Second flywheel.
Replacement Cord.
Allen key
Flywheel Washer
Flywheel Spacer
Self adhesive rubber feet (×6).
Rubber Bumper
Hanging Loop (+ fixings) see Chapter 15.
Wall Bracket (+ fixings) see Chapter 17.

Fitting the hanging loop

The hanging loop is a carry handle and the wall bracket adapter. Screw firmly to base moulding.
The hanging loop is packed with two screw plates and four self-tapping screws.
Insert the legs of the hanging loop into the base and secure firmly with the plates and screws as shown.
A: Hanging loop
B: 4× Screws
C: Screw plates

Fitting Instruction

Replacing the flywheel disc

Remove the flywheel with the supplied allen key.
Order flywheel – Space gym. club
Fit both discs with the washer and screw, NO SPACER!
Tighten flywheel screw firmly.
A: 1× Disc
B: Spacer
C: Washer
D: Screw
E: Allen Key
F: 2× discs

Wall and storage bracket

Also suitable as a wall anchor with 50kg fastenings.
Supplied with hanging loop to connect with unit.
Store your Space Gym on the wall.
Fitting directions and fasteners in bracket carton.
With strong 50kg anchors, lateral pull exercises extend your workout scope.
A: Wall bracket
B: Hanging loop

2 YEAR WARRANTY

This product has got a 2 year warranty

Dear Client, if for any reason this product is not working, please ensure you contact our
Client Service Centre. Ensure you have your original receipt of purchase. This warranty
covers all defects in workmanship or materials in this Batavia product for a two year period from the date of purchase. The warranty does not cover any malfunction, or defect resulting from misuse, neglect, alteration, or repair.

Customer Support

Dear customer

Please familiarize yourself with the proper usage of the device by reading and following each chapter of this manual, in the order presented. Keep these operating instructions for further reference.

Please read all safety instructions!

This manual contains important information on operating and handling the device.
Keep these operating instructions for further reference. Please pass it on along with the unit if it is handed over to a third party

01805 937 832
Other European countries – Customer Services
Monday till Friday from 8 am until 4 pm

00800 664 774 00