episode Terrain Series Satellite Speakers and Subwoofer Instruction Manual
- June 4, 2024
- episode
Table of Contents
Terrain Series Satellite Speakers and Subwoofer
Instruction Manual
ES-TERRAIN-SYS-4.1
ES-TERRAIN-HSUB-4.1
ES-TERRAIN-SAT-2.0
ES-TERRAIN-HSUB
ES-TERRAIN-SUB
INTRODUCTION
Welcome to Episode® Speakers. We appreciate your purchase and are committed to providing the highest-quality products possible.
IMPORTANT INSTRUCTIONS AND CONSIDERATIONS
Read and understand all instructions. Carefully plan the location and account for potential electrical, plumbing or other obstacles before beginning installation.
Package Contents
ES-TERRAIN-SYS-4.1
- (4) 4” Satellite speakers (stakes included)
- (1) 8” Burial subwoofer with 1.6’, 4-conductor burial wire
- (1) End cap for stake installation
- Silicone-filled wire nuts for all connections
ES-TERRAIN-HSUB-4.1
- (4) 4” Satellite speakers (stakes included)
- (1) 8” Hardscape subwoofer with 1.6’, 4-conductor burial wire
- (1) Base plate with mounting hardware
- (1) End cap for stake installation
- Silicone-filled wire nuts for speaker connections
ES-TERRAIN-SAT-2.0
- (2) 4” Satellite speakers (stakes included)
- Silicone-filled wire nuts for all connections
ES-TERRAIN-HSUB
- (1) 8” Hardscape subwoofer
- (1) Base plate with mounting hardware
- (1) Silicone-filled wire nuts for all connections
ES-TERRAIN-SUB
- (1) 8” Burial subwoofer
NOTE: Other mounting accessories are sold separately. Up to 8 speakers can be supported by a single two-channel or multichannel amplifier. Expand your system by ordering extra speaker pairs (ES-TERRAIN-SAT-2.0).
Additional Tools Required
- Wire stripper
- Rubber mallet
- Shovel
- Screws for base plate mounting (ES-TERRAIN-HSUB)
PLANNING THE PROJECT
The subwoofer is the heart of the outdoor system. Place it in a position that is as near to the center of the listening area as possible. To increase the perceived bass output, place the subwoofer next to a wall or other resonant/reflective surface.
The Terrain system is optimized to cover up to 278.71 sq. m. (3,000 sq. ft.)
with 8 satellite speakers. Place speakers evenly throughout the coverage area.
Place the satellite speakers around the listening area on each side of the
subwoofer, as evenly as you can. Space the satellite speakers 1.8–2.4 m 6–8
feet (6–8 ft.) apart for best coverage. Arrange the satellite speakers evenly
to minimize the variance of the sound texture.
Satellite Speaker Considerations
-
Using more speakers (to a maximum of 8) in an area allows for more even sound coverage.
-
Install speakers at ground level pointing toward the center of the area. This evens the sound texture and reduces sound escaping to other areas.
-
If using a stereo sound system, place left and right speakers evenly to avoid uneven sound in the area.
-
Do not aim speakers higher than 45° from the horizontal. This prevents water from collecting in the speaker driver. While water does not damage the speaker, it impedes performance and warps the sound. If water inside a speaker freezes, it can damage the speaker.
NOTE: An optional pivot bracket is required for horizontal adjustment. -
The speakers will not be damaged by normal rainfall; however, sprinkler systems may cause damage to the internal audio components. Avoid placing the speakers within direct sprinkler stream areas.
-
Clearance around the speaker is required for mounting, connecting, and adjusting the angle of the speaker.
-
Take care while selecting the mounting area so that the speakers do not become a trip hazard or an obstacle for landscaping equipment.
Speaker Wire Recommendations
We recommend using high-quality stranded speaker wire. Connect the left and
right wires from the AV receiver or amplifier directly to the corresponding
left and right binding posts on the speaker.
Use burial-rated wire for all installations. For maximum performance:
- For runs up to 30.48 m (100 ft.), use 16 ga wire or better.
- For runs up to 60.96 m (200 ft.), use 14 ga wire or better.
- For runs up to 91.44 m (300 ft.), use 12 ga wire or better.
You can use smaller wire gauges, but performance degrades depending on gauge and distance. The chart below shows the signal loss that you can expect on a typical run based on gauge and distance.
| Wire Gauge | Single Subwoofer | Dual Subwoofers |
|---|---|---|
| 21% Power Loss | 21% Power Loss | |
| 12 | 189.59 m (622 ft.) | 94.79 m (311 ft.) |
| 14 | 122.83 m (403 ft.) | 60.66 m (199 ft.) |
| 16 | 77.72 m (255 ft.) | 39.01 m (128 ft.) |
| 18 | 59.13 m (194 ft.) | 28.04 m (92 ft.) |
NOMINAL IMPEDANCE CHART
| 4.1 | 8 ohm |
|---|---|
| 6.1 | 6 ohm |
| 8.1 | 4 ohm |
| 4.2 | 4 ohm |
| 6.2 | 3.5 ohm |
| 8.2 | 3 ohm |
NOTE: Following the wiring recommendations for the Terrain system creates a nominal impedance on a standard multichannel or 2-channel amplifier. The chart above outlines the expected impedance per the system configuration.
INSTALLATION
Once you have laid out your plan and marked the positions on the ground, dig
the hole for the subwoofer and set it in place.
Couplers come attached to the satellites. Prior to installing the satellite
onto the stake, use the provided end cap and place it on top of each stake.
Drive the stake into the ground, removing the end cap once the stake is at the
proper depth. Note that the Quick Connect hole should be to the rear of the
intended aim of the speaker.
CAUTION: Do not drive the stake into the ground without using a provided end cap.
CONNECT
CAUTION: Do connect the speaker wire to the amp until all other
connections except power have been made.
CAUTION: Do not supply power to the amplifier until all other connections
have been made.
NOTE: The silicone-filled weatherized wire nuts included with this kit are specially designed for direct-burial installations. An equivalent connector must be used for any wiring in the system that is exposed to water or weather.
- Twist the source wires to the speaker head wires, then secure them using the weatherproof wire nuts. Silicone may squeeze out of the wire nut during this step; leave this on the wire for the best possible protection.
- Attach the speaker’s head to the stake. Ensure that the wires are not crimped, that the wires exit the speaker assembly below ground level, and that the coupler locks into place in the stake.
- Wire each channel from the amplifier through each channel on the subwoofer. IN/OUT are clearly labeled on the burial sub-wire. Up to four satellites can be wired in parallel off each side of the subwoofer matching +/+ and -/- on all satellites.
Burial Subwoofer
The subwoofer has four input connections. Using the wire nuts, connect both
left and right channels to the subwoofer, making sure positive and negative
connections are properly made.
Continue down the line and connect the rest of the speakers, then connect the
wires to the amplifier.
Ensure your volume is turned to zero. Connect your music source, power the
system, and test at various volume settings. Once everything is working
properly, fill all the holes and trenches.
Hardscape Subwoofer
Feed the subwoofer wire through the base plate’s wire channel then secure the
base plate to the deck/ground/patio using the four existing holes and provided
mounting hardware.
The Hardscape subwoofer has four input connections. Using the wire nuts, connect both the left and right channels to the subwoofer, making sure positive and negative connections are properly made. Place the Hardscape subwoofer over the base plate and secure it with the four provided screws. Plug all four holes with the provided rubber plug covers.
Continue down the line and connect the rest of the speakers, then connect the
wires to the amplifier.
Ensure your volume is turned to zero. Connect your music source, power the
system, and test at various volumes. Once everything is working properly, fill
all the holes and trenches.
Wiring Diagram
Other Uses for ES-TERRAIN Subwoofers
These DVC subwoofers can be paired with ES-AW-500 Series speakers when wired
in the configuration shown below with a 4-ohm-stable amplifier.
Burial Subwoofer
Hardscape Subwoofer
Note: Amplifier must be 4-ohm stable.
TROUBLESHOOTING
Episode speakers are designed to function trouble-free. Most problems that occur are due to simple issues. Refer to the list of fixes below, or contact Tech Support at 866.838.5052 if problems persist.
No Sound
- Verify that there is audio coming from the selected source. Select another source, if necessary to verify.
- Check the volume levels on the amplifier and source(s).
- Check that the proper source is selected on the amplifier or receiver.
- Check all wiring connecting the source(s) to the amplifier is plugged into the correct inputs and outputs.
Poor Sound
- Check audio cables if the sound drops out or if static is present.
- Check volume levels on every component in the system and ensure it does not exceed 80%.
SPECIFICATIONS
| Product | ES-TERRAIN-SYS-4.1 | ES-TERRAIN-HSUB-4.1 |
|---|---|---|
| Package Contents | 4 x 4” Satellite Speakers | |
| 1 x 8” Subwoofer | 4 x 4” Satellite Speakers |
1 x 8” Subwoofer
Height| Sat: 452.88 mm (17.83”) w/ stake.
143 mm (5.63”) w/o stake.
Sub: 566.42 mm (22.3”)| Sat: 452.88 mm (17.83”) w/stake.
143 mm (5.63”) w/o stake.
Sub: 302.26 mm (11.9”)
Width| Sat: 137.16 mm (5.4”)
Sub: 314.96 mm (12.4”)| Sat: 137.16 mm (5.4”)
Sub: 403.86 mm (15.8”)
Depth| Sat: 193.04 mm (7.6”)| Sat: 193.04 mm (7.6”)
Sub: 327.66 mm (12.9”)
Satellite Construction| 4” polypropylene cone woofer and 3/4” aluminum dome,
ferrofluid-cooled neodymium| 4” polypropylene cone woofer and 3/4” aluminum
dome, ferrofluid-cooled neodymium
Outdoor construction – High-strength ABS + glass construction| Outdoor
construction – High-strength ABS + glass construction
Subwoofer Construction| Oversized 1.5” high-power dual voice coil, 4-layer per
channel on the aluminum bobbin| Oversized 1.5” high-power dual voice coil, 4-
layer per channel on the aluminum bobbin
Outdoor construction with durable HDPE enclosure| Outdoor construction with
durable LLDP enclosure
Sat Crossover
Frequency| 125 Hz| 125 Hz
Color| Brown| Brown
Coverage Area| 278.71 sq. m. (3,000 sq. ft.)
(8.1 system)| 278.71 sq. m. (3,000 sq. ft.)
(8.1 system)
Nominal
Impedance| 8 ohm| 8 ohm
System Frequency
Response| 35 Hz to 20 kHz +/- 3dB| 35 Hz to 20 kHz +/- 3dB
Power RMS| 100W| 100W
Weight| 15.88 kg (35 lb)| 127.71 kg (28 lb)
Product
| ES-TERRAIN-SAT-2.0| ES-TERRAIN-HUB|
ES-TERRAIN-SUB
---|---|---|---
Package Contents| 2 x 4” Satellite Speakers| 1 x 8” Subwoofer| 1 x 8”
Subwoofer
Height| Sat: 452.88 mm (17.8”) w/stake.
143 mm (5.6”) w/o stake..| Sub: 302.26 mm (11.9”)| Sub: 566.42 mm (22.3”)
Width| Sat: 137.16 mm (5.4”)| Sub: 403.86 mm (15.9”)| Sub: 314.96 mm (12.4”)
Depth| Sat: 193.04 mm (7.6”)| Sub: 327.66 mm (12.9”)|
Satellite Construction| 4” polypropylene cone woofer and 3/4” aluminum dome,
ferrofluid-cooled neodymium| |
Outdoor construction – High- strength ABS + glass construction| |
Subwoofer Construction| Oversized 1.5” high-power dual voice coil, 4-layer per
channel on the aluminum bobbin| Oversized 1.5” high-power dual voice coil,
4-layer per channel on the aluminum bobbin| Oversized 1.5” high-power dual
voice coil, 4-layer per channel on the aluminum bobbin
Outdoor construction with durable HDPE enclosure| Outdoor construction with
durable LLDP enclosure| Outdoor construction with durable HDPE enclosure
Sat Crossover Frequency| 125 Hz| |
Color| Brown| Brown| Brown
Coverage Area| | |
Nominal Impedance| | Dual 8 ohm| Dual 8 ohm
System Frequency Response| | |
Power RMS| | 100W| 100W
Weight| 1.36 kg (3 lb)| 7.25 kg (16 lb)| 10.43 kg (23 lb)
PRODUCT DIMENSIONS
Satellite Speakers.
Burial Subwoofer
Hardscape Subwoofer
WARRANTY & REGULATORY
Find details of the product’s Limited Warranty and other safety, patent, and
legal resources at snapone.com/legal or request a
paper copy from Customer Service at 866.424.4489.
CONTACTING TECHNICAL SUPPORT
For chat and telephone, visit tech.control4.com/s/contactsupport • Email:
TechSupport@SnapOne.com. Visit
tech.control4.com for discussions, instructional
videos, news, and more.
Copyright ©2021, Snap One, LLC. All rights reserved. Snap One and its respective logos are registered trademarks or trademarks of Snap One, LLC (formerly known as Wirepath Home Systems, LLC), in the United States and/or other countries. 4Store, 4Sight, Control4, Control4 My Home, SnapAV, Episode, OvrC, Strong, SunBriteTV, Triad, and WattBox are also registered trademarks or trademarks of Snap One, LLC. Other names and brands may be claimed as the property of their respective owners. Snap One makes no claim that the information contained herein covers all installation scenarios and contingencies, or product use risks. Information within this specification is subject to change without notice.
211013
200-ES-TERRAIN-SERIES-B
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>