Metalux IB519098EN SN LED Commercial LED Strip Lights Instruction Manual

IB519098EN SN LED Commercial LED Strip Lights
Instruction Manual

Risk of Fire, Electrical Shock, Cuts or other Casualty Hazards- Installation and maintenance of this product must be performed by a qualified electrician. This product must  be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and hazards involved.
Risk of Fire and Electric Shock- Make certain power is OFF before starting installation or attempting any maintenance. Disconnect power at fuse or circuit breaker.
Risk of Fire- Minimum 90°C supply conductors.
Risk of Burn- Disconnect power and allow fixture to cool before handling or servicing.
**Risk of Personal Injury- Due to sharp edges, handle with care.
Failure to comply with these instructions may result in death, serious bodily injury and property damage.
DISCLAIMER  OF LIABILITY: Cooper Lighting Solutions assumes no liability for damages or losses of any kind that may arise from the improper, careless, or negligent  installation, handling or use of this product.
IMPORTANT: Read carefully before installing fixture. Retain for future reference.
NOTICE: Green ground screw provided in proper location. Do not relocate.
NOTICE: Fixture may become damaged and/or unstable if not installed properly.
Note: Specifications and dimensions subject to change without notice.
ATTENTION** Receiving Department: Note actual fixture description of any shortage or noticeable damage on delivery receipt. File claim for common carrier (LTL) directly  with carrier. Claims for concealed damage must be filed within 15 days of delivery. All damaged material, complete with original packing must be retained.

INSTALLATION

SN LED

1. Remove product from packaging. Channel covers are not fastened for installation purposes.
2. Wire according to code.
3. Install channel cover with screws provided (Figure 1.).

Row Aligner Instructions

1. Rotate end, pulling slightly the channel apart and pushing the bottom of the end (Figure 2.).
2. Bend the row aligner and separate it from end (Figure 3.).
3. Insert row aligner into channel. Insert wire holder if running a harness along the row of fixtures (Figure 4.).
4. Add screws on the side of channels (Figure 4.).
5. Insert harness into wire holder if applicable (Figure 5.).
   Note: Endplate must remain in place at end of row.

INSTALLATION

1. Remove the lens from the incoming protective material and set aside. Wire luminaire according to code. (Figure 1.)

2. Secure one side of the lens to the luminaire by sliding it along the channel cover until the lip of the lens is located beneath each of the lens clips. (Figure 2.)

3. Pivot the unsecured side of the lens toward the channel cover and squeeze it slightly in the areas where the lens clips are present, allowing the lip to be located beneath  the clip. (Figure 3.)
   Note: If luminaire is a high lumen package, secure lens to the end with short LED boards first.

4. Verify the lip of the lens is engaged in all (8) eight clips per 4ft section.

5. Center the lens of the luminaire as needed. (Figure 4.)

Installation Instructions – SN LED
IB519098EN www.cooperlighting.com

Cooper Lighting Solutions
1121 Highway 74 South
Peachtree City, GA 30269
P: 770-486-4800
www.cooperlighting.com
Cooper Lighting Solutions is a registered trademark.
All trademarks are property of their respective owners.
Product availability, specifications, and compliances are subject to change without notice

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>