OPT7 Aura Interior Car Lights LED Strip Installation Guide
- June 9, 2024
- OPT7
Table of Contents
OPT7 Aura Interior Car Lights LED Strip Installation Guide
INSTALLATION GUIDE
MAIN COMPONENTS
INSTALLATION
STEP 1
Decide where to locate the control box and ensure wiring has enough length for light bars to be installed in desired location.
IMPORTANT: The control box must be installed inside the vehicle as it is not waterproof. Avoid installation areas of the engine bay + heated surfaces.
As shown below, connect all the LED bars to the control box with the included extension cables.
IMPORTANT:
The extension wires are on the led bar. Lay out the bars to measure the length
prior to install for a successful installation.
4 × 24” LED Bar + 8ft extension wire
2 × 18” LED Bar + 18ft extension wire
2 × 18” LED Bar + 8ft extension wire
HOW TO CONNECT POWER HARNESS TO YOUR VEHICLE
- Connect the Red line(+) of power hareness to the vehicle battery’spositive terminal.
- Connect the Black line (-) of power hareness to the vehicle battery’s negativeterminal or an unpainted area on your vehicle’s frame.
- Connecting to more than 10 AMP will override the kit and cause early failure, ensure it is 10AMPs or less!!
- Please ensure that the LED bars or strips/control box/wiring all are mounted in areas where will not exceed 85℃ or 185℉.
STEP 2
Secure Control box in desired location with Velcro or zipties.
CONTROL BOX NOT WATERPROOF Ensure the control box is safely and securely
hidden from exposing elements of moisture.
STEP 3
Secure the light bars using the zip ties to tie all the wiring away from the moving components.
IMPORTANT:
The LED connectors are not waterproof. You will need to use HEAT SHRINK TUBE
(not included) or ELECTRICAL TAPE around the LED connectors to ensure the
longevity of the lighting kit.
STEP 4
Using the included E-Z Remote, select your desired color or pattern.
AUX WIRING FOR A DOOR/DOME LIGHT
Please scan to see a detail instruction on Door Assist Sync or go to
https://wintis.ladesk.com/549690-AURA-Door-AssistAUX-Installation Guide
CONTROL WIRE FOR A DOOR UNLOCK LIGHT
Please make sure the control wire (wire with the yellow sticker) is connected
to an “ACC/On” power source (SEE METHOD 1 FOR DETAILS); otherwise,when
unlocking it with the car keyfob, it will not trigger any light effects!!
NOTE: When remote unlock feedback is enabled, it will glow blue for 15 seconds.
STEP 1
Open the driver’s door. Then find the door access system control harness that
connects between the door frame and the door.
STEP 2
Pull off the harness cover and find the trigger wire that activates the door
lock/unlock.
IMPORTANT
HOW TO DIAGNOSE THE CORRECT TRIGGER WIRE?
First, you must prepare a multimeter. Next, please press the “Lock/Unlock”
button on the car keyfob to find out this signal source, this measurement
process may take you a little time, but it will ensure that you find the
correct signal you need.
STEP 3
Connect the control wire (red) to the trigger wire. Then connect the light bar
to the control box and use the car keyfob for a final tes
DISCLAIMER
OPT7 Lighting is not liable for damages or personal injuries while installing
this product. The Installation Guide is intended as assistance to reduce setup
time. OPT7 Lighting assumes no responsibility for improper installation.
If you are unfamiliar with your vehicle or inexperienced with aftermarket
upgrades, please seek professional assistance.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>