Leap Frog 80-615700 Touch and Learn World Map Instruction Manual

: June 9, 2024
: Leap Frog

Table of Contents

Leap Frog 80-615700 Touch and Learn World Map
INTRODUCTION
INCLUDED IN THE PACKAGE
INSTRUCTIONS
PRODUCT FEATURES
CARE & MAINTENANCE
TROUBLESHOOTING
Environmental Phenomena
FCC NOTE
ABOUT COMPANY
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Leap Frog 80-615700 Touch and Learn World Map

INTRODUCTION

Thank you for purchasing the Touch & Learn World Map™! Learn about the world’s countries, natural wonders, landmarks, animals and
more with this colorful and interactive world map.

INCLUDED IN THE PACKAGE

Touch & Learn World Map™
Quick Start Guide

WARNING
All packing materials such as tape, plastic sheets, packaging locks, removable tags, cable ties, cords and packaging screws are not part of this toy, and should be discarded for your child’s safety.
NOTE
Please save this Instruction Manual as it contains important information.

Unlock the Packaging Locks

Rotate the packaging locks 90 degrees counterclockwise.
Pull out the packaging locks and discard.

INSTRUCTIONS

Battery Removal and Installation

Make sure the unit is turned Off.
Find the battery cover located on the back of the unit, use a screwdriver to loosen the screw and then open the battery cover.
Remove old batteries by pulling up on one end of each battery.
Install 2 new AA (AM-3/LR6) batteries following the diagram inside the battery box. (For best performance, alkaline batteries or fully charged Ni-MH rechargeable batteries are recommended.)
Replace the battery cover and tighten the screw to secure

WARNING:

  * Adult assembly required for battery installation.
  * Keep batteries out of reach of children.

IMPORTANT: BATTERY INFORMATION

Insert batteries with the correct polarity (+ and -).
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
Only batteries of the same or equivalent type as recommended are to be used.
Do not short-circuit the supply terminals.
Remove batteries during long periods of non-use.
Remove exhausted batteries from the toy.
Dispose of batteries safely. Do not dispose of batteries in fire.

RECHARGEABLE BATTERIES

Remove rechargeable batteries (if removable) from the toy before charging.
Rechargeable batteries are only to be charged under adult supervision.
Do not charge non-rechargeable batteries.
NOTE
This product is in Try-Me mode in the packaging. After opening the package, slide the Off/Low/High Volume Selector to the Off position, then slide the Off/Low/High Volume Selector to the On position. If the unit powers down while playing, please install a new set of batteries.

PRODUCT FEATURES

Off/Low/High Volume Selector
To turn the unit On, slide the Off/Low/ High Volume Selector to the Low or High position. To turn the unit Off, slide the Off/Low/High Volume Selector to the Off position.
Interactive Touch Points
There are 200 interactive touch points throughout the map. Find the words and images with white borders, then touch them to explore. Hear names and fun facts about continents, oceans, countries, animals, natural wonders, landmarks and more. Touch the compass rose and legend to learn about map elements.
Explore Button
While in this mode, press any of the interactive touch points on the map to explore different parts of the world.
World Racer Button
In this game mode, players listen for the name of a country, then press the correct country name touch point on the map. Players have 60 seconds to locate as many correct answers as they can.
Animal Quest Button
In this game mode, players listen to a fun fact about an animal, then press the correct animal touch point on the map. Players are asked to find 5 different animals per game.
Landmark Expedition Button
In this game mode, players listen to a fun fact about a landmark or natural wonder, then press the correct landmark or natural wonder touch point on the map. Players are asked to find 5 different landmarks or natural wonders per game.
Automatic Shut-Off
To preserve battery life, the Touch & Learn World Map™ will automatically go into sleep mode after approximately 80 seconds without input. To turn the unit on again, press any button.

NOTE

The Touch & Learn World Map™ can be used on a table, on the floor or on the wall. For best results, however, we recommend hanging the map on the wall. Leaning on the map while it’s on the floor or table may trigger touch point responses accidentally.
Mount the map to the wall using the keyhole hanger on the back of the product. Do not place nails or tacks through the map itself.

WARNING
Do not fold or bend map; this could damage the electronic components in the map and prevent it from working properly.

CARE & MAINTENANCE

Keep the unit clean by wiping it with a slightly damp cloth.
Keep the unit out of direct sunlight and away from any direct heat sources.
Remove the batteries if the unit will not be in use for an extended period of time.
Do not drop the unit on hard surfaces and do not expose the unit to moisture or water.

TROUBLESHOOTING

If for some reason the unit stops working or malfunctions, please follow these steps:

Please turn the unit Off.
Interrupt the power supply by removing the batteries.
Let the unit stand for a few minutes, then replace the batteries.
Turn the unit back On. The unit should now be ready to use again.
If the unit still does not work, install a new set of batteries.

Environmental Phenomena

The unit may malfunction if subjected to radio-frequency interference. It should revert to normal operation when the interference stops. If not, it may become necessary to turn the power Off and back On, or remove and reinstall the batteries. In the unlikely event of an electrostatic discharge, the unit may malfunction and lose memory, requiring the user to reset the device by removing and reinstalling the batteries.

IMPORTANT NOTE:
If the problem persists, please call our Consumer Services Department at 1-800-701-5327 in the U.S. and Canada, or email support@leapfrog.com. Creating and developing LeapFrog products is accompanied by a responsibility that we take very seriously. We make every effort to ensure the accuracy of the information, which forms the value of our products. However, errors sometimes can occur. It is important for you to know that we stand behind our products and encourage you to contact us with any problems and/or suggestions you might have. A service representative will be happy to help you.

FCC NOTE

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

CAUTION
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Supplier’s Declaration of Conformity
47 CFR § 2.1077 Compliance Information

Trade Name: LeapFrog®
Model: 6157
Product Name: Touch & Learn World Map™
Responsible Party: LeapFrog Enterprises, Inc.
Address: 2200 Powell Street, Suite 500 Emeryville, CA 94608
Website: leapfrog.com
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.