ET2 Lighting E24770-133BK Sonata LED Wall Sconce Instruction Manual
- June 9, 2024
- ET2 Lighting
Table of Contents
TEM NUMBER: E24770-133BK
DESCRIPTION: Sonata LED Wall Sconce
Instruction Manual
E24770-133BK Sonata LED Wall Sconce
PLEASE CONSULT AN ELECTRICIAN BEFORE INSTALLATION
LAMPING: LED Integrated 12W
Vimput: 120V
MADE IN CHINA HECHO EN CHINA FABRIQUE EN CHINA
LED Lighting (LOW VOLTAGE)
Before Getting Started
Read the instructions carefully prior to assembling the product.
When you open the package with a sharp tool like a cutter knife, be careful
not to damage the components inside.
Carefully remove all packaging materials and retain for future use.
Keep all hardware parts and packaging out of reach of small children.
Choose a clean, level, spacious assembly area.
Avoid hard surfaces that may damage the product.
Ensure that you have all required contents for complete assembly.
Take care when lifting. Assemble the product in close proximity to where you
intend to position the item.
Do not over tighten the screws and bolts as this may damage the threads.
Do not let children play with this product.
- Risk of suffocation!
Keep any packaging materials away from children.
Low Voltage LED Lighting Instructions
Carefully read through the instruction sheet before assembly and using the
product.
Caution there is a risk of shock. Disconnect from power source before
assembling or cleaning.
WARNING: Wires need to be connected to driver found in canopy and should
not be connected directly to power source or a short may occur.
Do not cut factory connections unless instructed by the manufacturer
Do not plug the product in if cord is torn or frayed.
Cleaning & Maintenance
On polished finishes, often using talc powder reduces the appearance of
fingerprints and other smudges.
For respective shade surfaces, use the appropriate cleansers, i.e. glass
cleaner, acrylic polish, and wood polish.
Clean with soft cloth and a mild detergent.
DO not use abrasive cleaner.
Periodically (every 90 days) make sure that the screws are fully tightened.
Prolonged exposure to heat sources may cause glazing, melting and scorching,
or even cause color to fade.
Comtents
Before getting,started,ensure the package contains the following components:
| A | x1 | |
|---|---|---|
| B | M4*L12 SCREW | x2 |
| C | x1 | |
| D | #8-32*L25 SCREW | x2 |
| E | x3 | |
| F | M5*L35 SCREW | x2 |
| G | x2 |
WIRING DIAGRAM(ONLY FOR REFERENCE)
DO NOT ATTEMPT TO CUT FACTORY CONNECTIONS WITHOUT QUALIFIED
KNOWLEDGE.MODIFICATIONS MADE TO THIS PRODUCT WITEHOUT THE CONSENT OF THE
MANUFACTURER WILL VOID WARRANTY.
E24770-133BK
SCHEMATIC FOR GENERAL REFERENCE ONLY
if fixture does not light, reverse polarity.
FOR OPTIMAL USE
| Lutron: | Leviton: |
|---|
DVCL-153P
NTLV-603P
GT-250M
MACL-153M
PD-6WCL
DSL06
DV-600P
RRD-10ND| IPM10
6674
AWSMT-EB
Must be installed by a licensed electrician with knowledge of electronic lighting systems
SEND PRODUCT INQUIRIES TO
[email protected]