PowerPac PP2018 Cordless Hair Cutter Clipper User Manual
- June 13, 2024
- PowerPac
Table of Contents
RECHARGEABLE HAIR CUTTER
Power & Smooth Cut
Model: PP2018
PowerPac Electrical Pte Ltd
sales@powerpac.com.sg
www.powerpac.com.sg
PowerPacSg
@PowerPac4
PARTS & DESCRIPTION
LIST OF COMPONENTS
- Blade
- Guide Comb
- ON/OFF Switch
- USB Cable
- Cleaning Brush
- Oil
- USB Port
WARNINGS
ATTENTION :
Read this booklet carefully as it contains important instructions for a safe
installation, use and maintenance.
Important instructions to be kept for future reference.
The following basic precautions should always be followed when using
electrical appliances:
-
Read all instructions before using the appliance.
-
This appliance must be used only for the purpose it was expressly designed; any use NOT complying with the instructions contained in the manual is considered inappropriate and dangerous. The manufacturer is NOT responsible for possible damages caused by the inappropriate and/or unreasonable use.
-
This appliance is NOT suitable to be used or stored near heat sources (open flame, ovens, heaters, stoves, etc.) and/or in an explosive environment (in the presence of flammable substances such as gas, vapour, mist or dust, in atmospheric conditions when, after ignition, the combustion is spread in the air). Items containing these substances should never be placed in the appliance, and never be used to clean the appliance in order to avert the risk of fire or explosion.
-
The packing materials (plastic bags, expanded polystyrene, etc.) must be kept out of the reach of children or disabled persons since they represent potential sources of danger.
-
The installation/assembly of the appliance will be made in accordance with the indications of the manufacturer. A wrong procedure may cause damages to persons, animals or objects, for which the manufacturer cannot be considered responsible.
-
Before use, check the integrity of the appliance and power cable. In case you are not sure, contact a qualified person. If the power cable is damaged, it must be replaced by the manufacturer or its service agent or a qualified technician in order to avoid a shock hazard.
-
Before powering the appliance make sure the rating (voltage and frequency) corresponding to the grid and the socket is suitable for the plug of the appliance, and that the wall socket is properly grounded.
-
DO NOT power the appliance using multiple sockets. If possible, avoid the use of adapters and/or extension cables; if their use is absolutely necessary, use only materials in compliance with the current safety regulations and according to the electrical parameters of the adapters.
-
The appliance must NOT be switched on using external timers and/or other remote control appliances which are not specified in this manual.
-
Only use original components & accessories provided by the manufacturer. Any non-original components & accessories NOT recommended by the manufacturer may cause injuries to persons or damage to the appliance. Doing so will void the warranty and may cause serious injury.
-
If you are using the appliance for the first time, you should:
Fully charge the appliance for 16 hours. Subsequently, the charging process should last for 8 hours. Charge, use and store the dry appliance between —10°C (14°F) and 40°C (104°F). DO NOT charge or store the appliance in the bathroom or near water sources, nor use the appliance whilst it is being charged.
Ensure that the appliance is switched off before charging the appliance. Insert the connector of the power cable, and the plug of the appliance into the electric Disconnect the appliance when the Indicator light changes colour.
Ensure that the appliance is switched off before cleaning the appliance and accessories with a wet cloth mixed with some detergent.
DO NOT use metal scouring pads.
DO NOT clean any part of the appliance in the dishwasher.
Make sure to remove any label or protective sheet which may prevent its proper functioning.
DO NOT:
use the appliance to trim artificial hair or animal hair;
use the appliance on skin that is wounded, sunburnt, cut or blistered;
use the appliance in an inverted position as it may cause the Blade to cut too deep, leading to injury;
cover the appliance during functioning;
place the appliance in the microwave or conventional oven, or pour boiling water over any part of the appliance in order to sterilise it;
insert objects or body parts inside the protection cover of the appliance;
touch the Blade with your fingers or any utensil while the appliance is operating to avoid personal injury or damage to the appliance;
operate the appliance for more than 2 minutes without interruption. Let the appliance rest for 1 minute between processing cycles. After 3 processing cycles, allow an interval of 10 minutes to let the appliance cool down before the next use, so as to prolong its service life. DO NOT allow the appliance to idle while in operation;
press the ON/OFF Switch too forcefully;
leave the appliance unsupervised during operation. -
Before plugging & unplugging the appliance, turn the ON/OFF Switch to OFF. Plug and unplug the power cable holding it firmly with dry hands. Always unplug the power cable to avoid overheating and avoid stretching it (DO NOT pull it, tug it or use it to drag the appliance to which is connected).
-
During operation, DO NOT use the appliance whilst showering or touch the appliance with wet body parts, and it is recommended to have between you and the standing surface, an isolating element (for example, wearing shoes with rubber soles.
-
DO NOT immerse the appliance, excluding the Blade and the Guide Comb, in water or other liquids, wash it under the tap, or let any liquid flow into the internal casing of the appliance to prevent electric shock. The Blade and the Guide Comb can be rinsed under running water. DO NOT clean any part of the appliance in the dishwasher. In case of accidental fall in water, DO NOT attempt to remove it from the water, but first of all unplug immediately the’A’ connector of the USB power cable to the charging port of the external charger or computer.
HOW TO CLEAN AND MAINTAIN
-
Cleaning the appliance
Press the ON/OFF Switch to turn OFF the appliance. Remove the power cable from the appliance (if attached). DO NOT clean the appliance while it is being charged. -
Remove the Guide Comb from the appliance by sliding it up (see pictures under the heading “To Remove and Attach the Guide Comb”). You can clean the Guide Comb with detergent and rinse it under running water. Dry the Guide Comb before re-attaching it to the appliance.
-
Clean the Blade immediately after using the appliance. To remove the Blade (after removing the Guide Comb), hold the appliance and press your thumb against the flat section of the Blade and push upwards. You can rinse the Blade under running water. Refer to the pictures on how to clean the Blade using the Cleaning Brush.
-
If the exterior of the appliance is sticky, you can apply a proper amount of detergent and clean it with a soft wet cloth. DO NOT use cleaners or chemical substances.
Wipe the appliance’s surface with a dry cloth, Please dry or air dry the Blade aftercleaning, and then re-attach the Blade in the appliance. DO NOT use blowers, hairdryers or other dry heat exchanges.
DO NOT immerse the appliance, excluding the Blade and the Guide Comb, in water or other liquids, wash it under the tap, or let any liquid flow into the internal casing of the appliance to prevent electric shock. The Blade and the Guide Comb can be rinsed under running water. DO NOT clean any part of the appliance in the dishwasher. In case of accidental fall in water, DO NOT try to take it out, but first of all switch off and unplug the power cable immediately.
The Blades are sharp. DO NOT touch the Blades with your fingers to avoid personal injury.
DO NOT attempt to sterilise any part of the appliance at high temperatures as the plastic may deform.
To Remove and Attach the Blade
To adjust the level of trim required, simply slide the Guide Comb outwards to
increase the trim level and inwards to decrease the trim level.
To remove the Guide Comb, slide it completely out of the appliance in the
direction shown above.
To Attach the Guide Comb, slide it into the appliance in the opposite
direction.
To Remove and Attach the Blade
To remove the Blade, press your thumb against the flat section of the Blade
and push outwards in the direction shown in the picture on the left side.
The Blade should detach as shown in the picture on the right side.
To attach the Blade, insert the (1) Blade Clip (at the bottom of the Blade)
into the (2) notch in the appliance and press to snap the Blade into
place
To move the 2 set of teeth of the Blade slightly apart for cleaning
To push the 2 sections of Blade teeth slightly apart, holding the Blade, press
your thumb against the wedge
The 2 sections of Blade teeth should move slightly apart, as shown (pictures
at right)
Once the 2 sections are slightly apart, the Cleaning Brush can be used to
remove hair and dust from the Blades.
Press the white catch and squeeze 1 or 2 drops of oil between the 2 sections
of Blades.
How to Cut
Use the Guide Comb of the longest length the Guide Regulator allows if you are inexperienced in using the appliance.
-
To cut hair in the region: Nape of the Neck
Set the Comb length to 6 mm. Hold the appliance with the Blade teeth pointing upwards. Begin at the centre of the head at the base of the neck. Slowly lift the appliance as you work upwards and outwards through the hair, trimming a little at a time. -
To cut hair in the region: Back of the Head
Set the Comb length to 12 mm. Trim the hair at the back of the head. -
To cut hair in the region: Side of the Head
Set the Comb length to 6 mm and trim sideburns. Thereafter, set the Comb length to 12 mm and continue on to the top of the head. Repeat on the side. -
To cut hair in the region: Top of the Head
Set the Comb length to 12 mm and cut the hair on the top of the head against the direction of hair growth. To retain long hair, remove the Guide Comb from the appliance. Lift the hair on top of the head with a normal hand comb, and cut the hair over the comb. You can also use your fingers to lift the hair and cut it to the desired length. Always work from the back of the head upwards to the top of the head. -
To cut hair in the region: All parts of the head – the Finishing Touches Remove the Guide Comb from the appliance. Carefully trim the hair all around the head evenly.
ENVIRONMENTAL TIP
This device, along with all other electronic devices, should, when it is no
longer capable of functioning, be disposed with the least possible
environmental damage according to the local regulations in your area. In most
cases you can discard the device at your local recycling center.
DISPOSAL: Do not dispose this device as unsorted municipal waste.
Collection of such waste separately for special treatment is necessary.
WARRANTY
The manufacturer provides warranty in accordance with the legislation of the
customer’s own country of residence, with a minimum of 1 year, starting from
the date on which the appliance is sold to the end user.
The warranty covers defects in material and workmanship.
The repairs under warranty may only be carried out by an authorised service
centre.
When making a claim under the warranty, the original bill of purchase (with
purchase
date clearly indicated) must be submitted.
The warranty will not apply in cases of: normal wear and tear if the steps (as
laid out in the section regarding Warnings) have not been observed e.g.
overloading of the appliance, use of non-approved accessories if the appliance
has not been properly maintained, if force has been used against it or if it
has been damaged in any other way damage caused by non-observance of the user
manual or non-compliance with the installation instructions errors or faults
owing to defects in the distribution system if the appliance has been
repaired or modified or changed in any way or by any person not properly
authorised
SPECIFICATION
| MODEL | VOLTAGE | WATTS(W) |
|---|---|---|
| PP2018 | 220-240V ~ 50/60Hz | 2W |
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>