Hyperlite H2318 LED Canopy Lights Instruction Manual

Table of Contents

Product Specifications

Product: LED Canopy Light
Installation: Surface Mounted with J-box (Default) or Pendent with 3/4 inch Conduit (Optional)
Dimming Option: 0/1-10V Dimming
Colour Codes: Green/Yellow-Green (GND), White/Blue (N), Black/Brown (L), PUR (DIM+), Pink (DIM-), Pink (DC 0/1-10V(-)), Purple (DC 0/1-10V(+))

Installation – Surface Mounted with J-box (Default):

Loosen and remove the side M4 screws that are used to fix the mounting plate.
Fix the mounting plate to the ceiling with the screws.
Connect the clip on the fixture to the spindle of the mounting plate to ensure stability.
Connect the line voltage to the wires following the wiring diagram.
Push the pressing plate into the suspension loop on the mounting plate.
Lock the M4 screws to complete the installation.

Installation – Pendent with 3/4 inch Conduit (Optional):

(Skip if not using a dimmer)

Frequently Asked Questions:

Q: Can I install the LED Canopy Light without a qualified electrician?
A: No, installation and maintenance must be performed by a qualified electrician to ensure safety.
Q: What should I do before starting the installation or maintenance process?
A: Make sure to turn off the power at the fuse or circuit breaker to avoid any risks of fire or electric shock.

Thank you for purchasing our product. Please read the below articles carefully to see how to use this product safely.

Warning
Contents and attention contents related to product safe use, please be sure to follow it.

Risk of Fire, Electrical Shock, Cuts or other Casualty Hazards- Installation and maintenance of this product must be performed by a qualified electrician. This product must be installed by the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
Risk of Fire and Electric Shock- Make certain power is OFF before starting installation or attempting any maintenance. Disconnect power at the fuse or circuit breaker.
Risk of Fire- Minimum 90°C supply conductors.
Risk of Burn- Disconnect power and allow the fixture to cool before handling or servicing.
Risk of Personal Injury- Due to sharp edges, handle with care.
Failure to comply with these instructions may result in death, serious bodily injury and property damage.

Attention

To avoid electric shock, disconnect the power at the source before installation.
Do not touch the fixture while it is in service.
To prevent early product failure, luminaire should only be used in operating environments ranging from -35°C to 55°C.
If there is any problem with the fixture, DO turn off the power and DO NOT attempt repair unless you are a qualified technician.

Surface Mounted with J-box (Default)
Loosen and remove the side M4 screws that are used to fix the mounting plate.
Fix the mounting plate to the ceiling with the screws.
Connect the clip on the fixture to the spindle of the mounting plate to make sure the fixture will not slip and fall. Connect the line voltage to the wires coming out from the fixture following the wiring diagram. Push the pressing plate into the suspension loop on the mounting plate.
Lock the M4 screws to complete the installation.
Pendent with 3/4 inch Conduit (Optional)
Connect the line voltage to the wires coming out from the fixture following the wiring diagram.
Screw the fixture to the 3/4 inch conduit to complete the installation. $Hyperlite-H2318-LED-Canopy-Lights-Fig- $6$$