ET2 Contemporary Lighting E42080-90PC Luminance 24×30 Inch Mirror Instruction Manual
- June 8, 2024
- ET2 Contemporary Lighting
Table of Contents
**ET2 Contemporary Lighting E42080-90PC Luminance 24×30 Inch Mirror
**
Install the Fixtures
-
Ensure that the electrical box is located behind the mirror location.
-
Using the paper template (provided) and a fixture; level, measure, and mark the location of mirror(s) and fixtures.
-
Place the fixture on the marked location and mark the location of the holes for the fixture
Note: Ensure that the mounting holes are located behind the mirror
-
At a mounting hole location, push the anchor into the wall up to the threads.
-
Screw the anchors in the rest of the way with a Phillipshead screwdriver.
-
Repeat steps 4-5 for the other anchors and screw.
Wiring Driver & Fixtures -
Connect the white driver wire to the neutral power line.
-
Connect the black driver wire to the hot power line.
-
Properly place the driver input wires, and wire nut connections into the electrical box.
-
Feed the fixture wires through the mounting plate center hole .
-
Connect the lead wire of fixture marked “+” to Led driver output wire marked “+”with connector, and connect the lead wire of fixture marked “-” to Led driver output wire marked “-”with connector. Never connect the wire with “+” to wire with “-”.
2 Multiple mirror’s driver installation
-
Properly place the wires and wire nut connections inside
the electrical box. -
If necessary push any excess fixture wire into the electrical box through the mounting plate.
-
Attach the mounting plate to the electrical box using the two #8-32 screws provided.
Install the Mirror
-
Drill holes for installation the bracket
-
Place the wall anchors into holes
-
Mount the bracket with screws
-
Hang the mirror onto bracket and secure the part at the backside of bottom mirror with T screws if needed.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>