SIGOR 9057801 LED Power Supply Unit DALI RGB 100W Instructions

: June 9, 2024
: SIGOR

Table of Contents

SIGOR 9057801 LED Power Supply Unit DALI RGB 100W
Function introduction
Product Data
Safety & Warnings
Operation
Wiring diagram
Product Dimension
ABOUT COMPANY
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

SIGOR 9057801 LED Power Supply Unit DALI RGB 100W

SIGOR-9057801-LED-Power-Supply-Unit-DALI-RGB-100W-
fig-1

Function introduction

SIGOR-9057801-LED-Power-Supply-Unit-DALI-RGB-100W-
fig-2

Product Data

Output

| LED Channel| 4 Channel
---|---|---
DC Voltage| 24V DC
Max. Current| Max. 4.17A（CH1+CH2+CH3+CH4≤4.17A）
Voltage Tolerance| ±3%
Rated Power| Max. 100W

Input

| Voltage Range| 220-240V AC
Frequency Range| 50/60Hz
Power Factor (Typ.)| > 0.97 @ 230VAC
Total Harmonic

Distortion

Control

Protection

| Over Voltage| Yes, recovers automatically after fault condition is removed
Over Load| Yes, recovers automatically after fault condition is removed
Short Circuit| Yes, recovers automatically after fault condition is removed
Over temperature| Yes, recovers automatically after temperature drop

Environment

| Working Temp.| -25℃ ~ +45℃
---|---|---
Max. Case Temp.| 85℃ (Ta=”45℃”)
Working Humidity| 10% ~ 95% RH non-condensing
Storage Temp. & Humidity| -40℃ ~ +80℃, 10% ~ 95% RH

Safety & EMC

| Safety Standards| IEC/EN61347-1, IEC/EN61347-2-13
Withstand Voltage| I/P-O/P: 3.75KVAC
Isolation Resistance| I/P-O/P: 100M Ohms / 500VDC / 25℃ / 70% RH
EMC Emission| En55015, EN61000-3-2 Class C, EN61000-3-3
EMC Immunity| EN61000-4-2,3,4,5,6,8,11, EN614547

Others

|

MTBF

| 191500H, MIL-HDBK-217F @ 230VAC full load and 25°C

ambient temperature

Dimension| 306.64330mm (LWH)
Warranty| 5 Years

Dimmable LED driver, max. output power 100W total
In compliance with IEC 62386-101:2014, IEC 62386-102:2014, IEC 62386-207 Ed2, IEC 62386-209:2011
Built-in DALI-2 interface, DALI DT8 device
4 channels DC 24V constant voltage output
High power factor and efficiency
Built-in DALI interface, DALI DT8 device, each device is controlled via a single DALI address
PWM dimming.smooth and deep dimming to 0.1%
Compatible with universal DALI masters that support DT8 commands
Error report function, support DALI DT8 Tc type
IP20 rating, suitable for indoor LED lighting applications
5 years warranty

Safety & Warnings

DO NOT install with power applied to the device.
DO NOT expose the device to moisture.

Operation

DALI Address
DALI address for 4 channels output are assigned by DALI Master controller automatically, please refer to user manuals of compatible DALI Masters for specific operations.
PUSH Dimmer Mode
While connected with a AC PUSH, the driver will be in Push Dimmer Mode, operations under Push Dimmer Mode
are as follows:
Click the button to switch ON/OFF repeat the operation to adjust light intensity to opposite direction. The dimming range is from 0.1% to 100%.
Press and hold down the button to increase or decrease light intensity to desired level and release it, then
Memory function after power off or power failure enables the device to memorize the status before power off while power on again.