SIGOR 9057901 DALI 150W Power Supply incl RGB control User Manual
- June 8, 2024
- SIGOR
Table of Contents
SIGOR 9057901 DALI 150W Power Supply incl RGB control
Function Introduction
Product Data
Output
| LED Channel| 4 Channel
---|---|---
DC Voltage| 24V DC
Max. Current| Max. 6.25A(CH1+CH2+CH3+CH4≤6.25A）
Voltage Tolerance| ±3%
Rated Power| Max. 150W
Input
| Voltage Range| 220-240V AC
Frequency Range| 50/60Hz
Power Factor (Typ.)| > 0.98 @ 230VAC
Total Harmonic
Distortion
| THD ≤ 6% (@ full load / 230VAC)
Efficiency (Typ.)| 93% @ 230VAC full load
AC Current (Typ.)| 0.71A @ 230VAC
Inrush Current (Typ.)| COLD START Max. 46A @ 230VAC
Leakage Current| < 0.5mA /230VAC
Standby Power Consumption| < 0.5W
Anti Surge| L-N:2KV
Control
| Dimming Interface| DALI DT8 (DALI consumption<2mA)/ Push
Dimming Range| 0.1%-100%
Dimming Method| Pulse Width Modulation
Dimming Curve| Linear/Logarithmic optional
Protection
| Over Voltage| Yes, recovers automatically after fault condition is removed
Over Load| Yes, recovers automatically after fault condition is removed
Short Circuit| Yes, recovers automatically after fault condition is removed
Over temperature| Yes, recovers automatically after temperature drop
Environment
| Working Temp.| -25℃ ~ +50℃
---|---|---
Max. Case Temp.| 85℃ (Ta=”50℃”)
Working Humidity| 10% ~ 95% RH non-condensing
Storage Temp. & Humidity| -40℃ ~ +80℃, 10% ~ 95% RH
Safety & EMC
| Safety Standards| IEC/EN61347-1, IEC/EN61347-2-13
Withstand Voltage| I/P-O/P: 3.75KVAC
Isolation Resistance| I/P-O/P: 100M Ohms / 500VDC / 25℃ / 70% RH
EMC Emission| En55015, EN61000-3-2 Class C, EN61000-3-3
EMC Immunity| EN61000-4-2,3,4,5,6,8,11, EN614547
Others
|
MTBF
| 191800H, MIL-HDBK-217F @ 230VAC full load and 25
ambient temperature
Dimension| 365.64330mm (LWH)
Warranty| 5 Years
- Dimmable LED driver, max. output power 150W total
- In compliance with IEC 62386-101:2014, IEC 62386-102:2014, IEC 62386-207 Ed2, IEC 62386-209:2011
- Built-in DALI-2 interface, DALI DT8 device
- 4 channels DC 24V constant voltage output
- High power factor and efficiency
- Standby power consumption is less than 0.5W and meets the latest ERP standards.
- Built-in DALI interface, DALI DT8 device, each device is controlled via a single DALI address
- PWM dimming, smooth and deep dimming to 0.1%
- Compatible with universal DALI masters that support DT8 commands
- Error report function, support DALI DT8 Tc type
- IP20 rating, suitable for indoor LED lighting applications
- 5 years warranty
Safety & Warnings
- DO NOT install with power applied to the device.
- DO NOT expose the device to moisture.
Operation
DALI Address
1 DALI address for 4 channels output is assigned by the DALI Master controller
automatically, please refer to user manuals of compatible DALI Masters for
specific operations.
PUSH Dimmer Mode
While connected with an AC PUSH, the driver will be in Push Dimmer Mode,
operations under Push Dimmer Mode are as follows:
- Click the button to switch ON/OFF
- Press and hold down the button to increase or decrease light intensity to the desired level and release it, then repeat the operation to adjust light intensity to the opposite direction. The dimming range is from 0.1% to 100%.
- Memory function after power off or power failure enables the device to memorize the status before power off while powering on again.
Wiring diagram
- With DALI Bus
- With Push Dim
Product Dimension
Sigor Licht GmbH
Eichenhofer Weg 81 · 42279 Wuppertal
Telefon 0 23 39 – 12 61 0 · Telefax 0 23 39 – 12 61 61
info@sigor.de. www.sigor.de.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>