GUDE GGH 30 R 85160 Gas Heater User Manual
- June 9, 2024
- Gude
Table of Contents
GUDE GGH 30 R 85160 Gas Heater
Scope of delivery
INTRODUCTION
The product is designed for use by persons aged 16 or older. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.
WARNING
GAS / ON
START
STOP
Specified Conditions of Use
This product is only suitable for occasional use. The gas fan heater is
designed for heating, drying buildings and de-icing and must only be operated
in well-ventilated rooms or outdoors. Ventilation openings of at least 750 cm2
must be available in the room where the appliance is installed (at least 25
cm2 per 1 kW rated heat output). The minimum room size must not be less than
300 m3 (1 m3 per 100 W rated heat output). When using the device, the
respective local building and fire protection regulations must be observed.
Please note that our equipment has not been designed for commercial, craft or
industrial use. If the equipment is used in commercial, craft or industrial
operation or for similar activities, we cannot assume any liability. Do not
use this product in any other way as stated for normal use. Not observing
general regulations in force and instructions from this manual does not make
the manufacturer liable for damages.
The gas heater must not be used
The device must not be operated in environments or rooms below ground
level. Do not install the device in rooms at risk of explosions and fire. In
the vicinity of combustible materials (e.g. paper, building materials); An
explosive atmosphere may be created in places where volatile materials (e.g.
gasoline, solvents, chemicals) are stored or present; The apparatus is not
intended for drying of clothing or for installation under benches or in floor
trenches. Do not use the device in animal husbandry or animal breeding. After
an arbitrary structural change in the gas heater; The heater may not be
operated without a fire protection grille in its designated location. Only
operate the device when it is fully assembled! In case of wrong, unauthorised
connection to a gas source; In places that are not sufficiently ventilated; As
a source of heat for events and festivals.
Emergency procedure
Conduct a first-aid procedure adequate to the injury and summon qualified medical attendance as quickly as possible. Protect the injured person from further harm and calm them down. If you seek help, state the following f you seek help, state the following pieces of information: es of information:
- Accident site
- Accident type
- Number of injured persons
- Injury type(s)
Safety instructions for Gas fan heater
Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Only use the device in a well-ventilated environment and away from combustible materials. Do not use or store explosive or flammable materials (e.g. fuel, paper, paints) in the vicinity of the product. Keep the following safety distances: Air intake side 2,5 m; Air outlet side 3,5 m; side 2,0 m; top 2,0 m; back 2,5 m. Do not put foreign objects in the device. Make sure that the fan is operating properly before igniting the burner. Never place the gas cylinder in front of the gas fan heater when it is in use! This is a fire hazard! It must always be ensured that air can be taken in and vented freely. The devices may not be used in atmospheres that contain oil, sulphur or salt. Do not set up in rooms at risk of fire (e.g. wood sheds). Do not use this heater with a program switch, a time switch, a separate remote control system or any other device that automatically switches the heater on, as there is a risk of fire if the heater is covered or set up incorrectly. Always switch off the device, as described in this manual, if you cannot leave it in a safe state. Secure the device against unauthorised use, e.g. by enclosing the gas cylinders. Leave the premises, move to a clear place and warn other people
Danger of short circuit!
Never operate/touch the device with wet hands. Protect the electrical parts from moisture. To prevent electrical shock, never submerse these parts in water or other fluids during cleaning or when in operation. Never hold the apparatus under flowing water. Switch off the device and disconnect it from the power supply before replacing accessory parts, cleaning work and if it is not in use. Operation is only allowed with a safety switch against stray current (RCD max. stray current of 30mA).
Symbols
Operation
An unpleasant smell may be produced when the device is used for the first time in some cases. This is however completely harmless and will disappear completely over time. Before each use, check the device and its connecting parts and accessories for damage.
Power on
- Connect the pressure regulator to the gas cylinder valve.
- Connect the gas hose to the pressure regulator.
- Connect the gas hose to the heater.
- Open the gas cylinder valve.
- Check screw caps with leak detection spray or soapy water for possible gas leakage. Tighten again if necessary.
- Put the mains cable into a suitable socket.
- Press the On/Off switch to switch on the device.
- From the intake side, check whether the fan is rotating.
- If the fan is turning, keep the gas valve button pressed and at the same time press the ignition button repeatedly until the burner ignites.
- Keep the gas valve knob pressed for approx. 10 seconds until the thermal fuse has warmed up and keeps the gas supply open.
- Check that the gas heater is running continuously.
- Use the control dial to adjust the heat output to the desired level.
Power off:
- To switch off the gas heater, always close the gas cylinder valve first.
- Run the fan for 1-2 minutes to blow out any noncombusted gas and to cool down the unit.
- Switch the device off with the On/Off switch.
- Pull out the mains plug to disconnect the device from the mains.
- Disconnect the device from the gas cylinder by unscrewing the pressure regulator from the gas cylinder valve.
- Carry out the maintenance and cleaning work described in the instructions. Please note the intervals mentioned. (once a month, every 50 operating hours, after each season)
Handling of gas bottles.
Make sure the gas bottles are used and stored in rooms with sufficient air
inlet and outlet. A leaking gas bottle may reduce the share of oxygen in the
inhaled air and therefore represent a risk of suffocation. Before using the
device, always check that the pressure controller seal is correctly fitted and
working properly. Before use, make sure the gas bottle contains gas designed
for the work being done. Gas bottles must always be safely fixed in a vertical
position on a wall support or on a specially manufactured gas bottle cart. The
liquid gas cylinder must be changed in a well-ventilated room or outdoors, and
away from open flames (cigarettes, candles or other devices with open flames).
A gas cylinder with a pressure regulator attached must not be moved. Close the
gas bottle valve after use. The gas bottle valve must be closed during
transport.
Smell of gas or suspect leakage
If you smell gas or suspect a leak, do not use the device. If the device is in
use, the gas supply must be shut off immediately. Immediately open windows and
doors. Do not press any electrical switches (e.g. light switches), do not use
a telephone or similar and do not use any naked flames or sources of ignition!
The device must be checked and any faults remedied before it can be used
again.
Emergency procedure
- Stop the gas supply to the device.
- Move out of the danger zone immediately and make sure that no other persons are in the danger zone.
- Call the fire brigade.
Maintenance
All activities that require the device to be opened may only be carried out by Güde or authorised specialist companies. Have the device checked annually or after a longer period of storage by a specialist electrical company to ensure that it is in good working order. Check the gas hose lines at least once a month as well as every time the gas cylinder is replaced. If there are any signs of damage, the hose lines must be replaced. The entire device must be checked for correct function including a leak test, once a month. A leak test can be carried out with a leak detection spray or soapy water, for example. Clean the fan blades and the inside of the heater with compressed air every season or as needed. Always keep children and unauthorised persons out of reach of the appliance. Repairs and works specified in these instructions may only be performed by qualified authorised staff. Use only original accessories and original spare parts. Keep the device, in particular the air vents, clean at all times. Never spray water on the device body! Do not clean the plastics with solvents, flammable or toxic fluids. For cleaning, use a damp cloth only. Only a regularly maintained and treated appliance can serve as a satisfactory aid. Insufficient maintenance and care can lead to unforeseen accidents and injuries.
Technical Data
Storage
- Close the gas cylinder valve.
- Turn off the device and disconnect it from power supply. (» Power off)
- Unscrew the pressure regulator from the gas cylinder.
- Remove the gas cylinder from the device.
- Leave the device to cool after use
Disposal
Do not dispose of electrical appliances in household waste; use the local
collection points. Ask your local authority where the collection points are to
be found. If electrical equipment is disposed of in an uncontrolled manner,
weathering can lead to dangerous substances entering the groundwater and from
there the food chain, or the flora and fauna can be poisoned for years. If you
replace the device with a new one, the seller is legally obliged at the least
to take back the old one to be disposed of free of charge
Transport packaging disposal
The packaging protects the machine against damage during transport. Packaging
materials are usually chosen based on environment aspects and waste treatment
principles and are therefore recyclable. Returning the packaging into material
circulation saves raw materials and reduces waste production. Parts of
packagings (e.g. foils, styropor®) can be dangerous for children.
Risk of suffocation! Keep parts of the packagings out of reach of children and dispose them as soon as possible
Service
Do you have any technical questions? Any claim? Do you need any spare parts or operating instructions? We will quickly help you and without needles bureaucracy at our web pages at www.guede.com in the Servicing part. Please help us be able to help you. In order to identify your device in case of claim we need the serial No., product No. and year of production. All this data can be found on the type label.
- Tel.: +49 (0) 79 04 / 700-360
- Fax: +49 (0) 79 04 / 700-51999
- E-Mail: support@ts.guede.com
Failure removal
Warranty
Warranty period of 12 months applies to commercial use and 24 months applies to private use and commences on the day of purchase of the device. The guarantee solely covers inadequacies caused by material defect or manufacturing defect. Original payment voucher with the sales date needs to be submitted for any claim in the guarantee period. The guarantee does not cover any unauthorised use such as appliance overloading, use of violence, damage as a result of any unauthorised interference or caused by foreign items. Failing to follow the operating and assembly instructions and common wear are also not included in the guarantee.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>