ANOLIS ArcSource Inground 24MC Instruction Manual

: June 8, 2024
: ANOLiS

Table of Contents

ArcSource Inground 24MC
Documents / Resources

ARCSOURCE™ INGROUND 24MC
INSTALLATION INSTRUCTIONS

ArcSource Inground 24MC

The unit must be installed by a qualified electrician in accordance with all applicable regulations including local and national construction and electrical codes. This device falls under class I and must be grounded!
STEP 1
PREPARE SLEEVE AND LUMINAIRE

Remove temporary installation sleeve cover plate.
Remove junction box cover.

STEP 2
CONNECTION

Strip these lengths for cable connections.
| A| B
---|---|---
Power Connection| 7mm| 70mm
DMX Connection| 7mm| 70mm
Connection – colour coding
DMX Connection0| −| +
---|---|---
Data Ground| Data –| Data +

Power Connection

| L| N| GROUND
---|---|---|---
Core (EU)| Brown| Blue| Green/Yellow
Core (US)| Black| White| Green
3. Connection ANOLIS ArcSource Inground 24MC - FIGURE 4 4. Wiring connection

STEP 3
CABLE GLAND INSTALLATION
Put cable thru cable gland M20x1.5 and connect into connection terminal. Assemble cable gland as shown below. Use wrench size 24 for cable gland M20x1.5

ANOLIS ArcSource Inground 24MC - FIGURE 6

Apply Loctite 5331 thread sealant on the plastic holder and Loctite 577 thread locking compound on the gland body in the indicated locations prior to assembly.
Failure to properly install cable glands will result in failure of the water tight seal!
STEP 4
CLOSE JUNCTION BOX

ANOLIS ArcSource Inground 24MC - FIGURE 7

Cover junction box. Before applying the torque, make sure the thread is clean and functional.
STEP 5
INSTALLATION OF ARCSOURCE INGROUND

Insert the ArcSource Inground into the installation sleeve and adjust it to desired position.
There is a projection and the pad on the sleeve housing and the notches on the ArcSource Inground in order to facilitate adjusting of the ArcSource Inground towards the sleeve. The centre of the notches on the ArcSource Inground also indicates the axis around which the LED module tilts.
Installation of protectors behind If units are installed in a row, keep the projection on the sleeve housing on the same side at all units to keep the same direction of tilting of LED modules.
Secure the ArcSource Inground 24 MC Integral in desired position
Insert top flange on the ArcSource Inground and screw it on the sleeve. Before applying the torque, make sure the thread is clean and functional.

STEP 6
BEAM TILT ADJUSTMENT
The fixture beam can be tilted ±15° from a vertical axis by means of the item “tilt” in the fixture menu. Adjusted position of the LED module is permanent kept ,also after disconnected the fixture from mains. During the tilt adjustment, a white beam will appear.

ANOLIS ArcSource Inground 24MC - FIGURE 13

ROBE lighting s. r. o.
Palackeho 416
757 01 Valasske Mezirici
Czech Republic
Tel.: +420 571 751 500
E-mail:info@anolis.eu
www.anolis.eu
www.anolislighting.com
VERSION 1 / 12_05_2021