CLOSETMAID 1220 Utility Hook Installation Guide
- June 8, 2024
- ClosetMaid
Table of Contents
CLOSETMAID 1220 Utility Hook
Utility Hook Installation Instructions
The Utility Hook can be mounted on a door or wall. See reverse side for wall mounting.
DOOR MOUNTING
-
Hang mounting hooks over top of door as shown.
-
Place top horizontal wire of utility hook behind mounting hooks. Insert bottom horizontal wire into both hooks as shown.
-
Attach each mounting hook to door with two 1/2” screws (provided). If door is hollow, use hollow door anchors (available at hardware store) and follow manufacturer’s instructions for installing anchors.
-
If plastic endcaps are not attached, place over exposed wire ends.
SPECIAL NOTE FOR CUSTOMERS IN EUROPE:
Door type shown in “A” requires a different hook. Please use the hook which
best fits your door.
WALL MOUNTING
-
Mark two mounting hole locations as shown. Be sure marks are on a level line.
-
Use a 1/4” drill bit to drill mounting hole locations. Insert anchors (provided) into holes.
-
Attach utility hook to wall with two 1” screws (provided).
-
If plastic endcaps are not attached, place over exposed wire ends.
Customer Support
©2021 The AMES Companies, Inc. | Orlando, FL 32827 |
1-800-874-0008
| www.closetmaid.com |
www.closetmaid.ca
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>