SFA SANIACCESS 3 Sewage Lifting System Instruction Manual
- June 8, 2024
- SFA
Table of Contents
SANIACCESS 3 Sewage Lifting System
Instruction Manual
SANIACCESS 3 Sewage Lifting System
SANIFLO Ltd.,
Howard House, The Runway
South Ruislip Middx.,
HA4 6 SE
Tel. +44 208 842 0033
Fax +44 208 842 1671
SERVICE HELPLINES
United Kingdom
08457 650011 (Call from a land line)
DESCRIPTION
This macerator is (manufactured in a factory which is quality) certified to
ISO 9001.
Installed and used correctly, the unit will give consistent and reliable
service.
This device is not designed for persons (including children) with limited
physical, sensory or mental abilities, or those with minimal experience
andknowledge,unless they are monitored and are given the necessary
instructions for using the device, with the help of a person responsible for
their safety.Monitor children and make sure they do not play with the device.
APPLICATIONS
This appliance is a compact lift pump unit designed for removing waste water
from a horizontal outlet toilet, shower, bidet or washbasin (*: depending
on the model).
This appliance conforms to EN 12050-3 and the European standards concerning
electrical safety and electromagnetic compatibility.
To view the DoP (Declaration of performance) please click on the
‘Illustrations and Datasheet’ tab on each product page on our website.
INSTALLATION
The unit should be accessible for possible service. The fitting and working of your appliance must meet local regulations and the EN 12056-4 standard. To optimise the latest technical developments concerning soundproofing incorporated into this unit, it is important to:
- position the WC pan so that it is not in contact with a partition or wall of the room
- place the WC pan on a perfectly level surface to ensure that the resilient mounts are fully efficient
- fix the discharge pipe correctly, with distances of not more than one metre between the fastenings.
CONNECTION TO THE ELECTRICAL SUPPLY
The electrical installation should be carried out by a qualified person. The unit requires a 220/240V single phase AC 50 Hz supply (UK specification). The power supply circuit of the appliance must be earthed (Class I) and protected by a GFCI high sensitivity (30mA). Warning: Ensure the electricity is turned OFF at the main switch board before wiring to connector.
All wiring must conform to BS7671, 1992 requirements for electrical installations. Do not connect the unit to a conventional plug and socket. It must be wired into a fused, unswitched, fixed wiring connector fitted with a 5 amp fuse. The wires in the mains lead are coloured in accordance with the following code: Brown – Live Blue – Neutral Green/Yellow – Earth The connection must be used exclusively to power the device. All work on cable, pressure chamber and motor should only be carried out by a qualified Saniflo servicing agent, as special tools are required. Please do not cut/ shorten the electrical supply cable which can make it very difficult to remove in the event of a service requirement.
COMMISSIONING THE UNIT
Flush the WC checking that all seals, and connections are watertight.
Check both the discharge pipework from the unit and the other sanitary
appliances connections. Check the watertightness of connections to sanitary
appliances: toilet, shower, bidet or washbasin (*:depending on the model).
MAINTENANCE
WARNING !!! In the event of prolonged absence it is essential to turn off
the water supply to protect the installation against sub zero temperatures.
CARE OF YOUR UNIT
In order to remove scale and clean the macerator and the bowl, use the SANIFLO
Cleanser/Descalent.
- Disconnect the macerator power supply,
- Pour an amount of cleanser into the pan
- Leave it to stand for 1 or 2 hours,
- Re-connect the macerator power supply,
- Rinse by operating the flushing system twice.
Carry out the operation once every 3 months on average, but the frequency may need to be changed depending on the hardness of the water.
FAULT FINDING/REMEDIES
IN ALL CASES, YOU MUST DISCONNECT THE MACERATOR FROM THE POWER SUPPLY
SYMPTOMS | PROBABLE CAUSES | REMEDIES |
---|---|---|
• The motor does not activate | • The electrical power supply is not active |
• The electrical power supply is defective
• The motor or the control system is defective| • Restore the electrical
supply
• Check the electrical power supply
• Otherwise, ask an approved repair agent to intervene
• The motor emits a rattling or
crunching sound, hums, but
does not run| • Foreign object into the box
• Problem with the motor or the control system| • Remove the foreign body
• Otherwise, ask an approved repair agent to intervene
• The motor intermittently
activates| • The connected sanitary devices are dripping water
• The non-return valve is faulty| • Check the installation upstream
• Clean or replace the non-return valve
• The motor operates normally, but
continues to run for a long time| • The length or height of the installation
is over the specification, or there are too many bends/elbows
• The pump cover plate is partially obscured/blocked| • Check the installation
• Otherwise, ask an approved repair agent to intervene
• The unit stops| • The unit has been running for too long (thermal cut-out)|
• Wait for reset, then ask an approved repair agent to intervene
• Motor is surging and water in the WC pan goes down
very slowly| • The air dispenser is clogged up
• Problem with motor| • Clear the air relief hole
• Otherwise, ask an approved repair agent to intervene
• Cloudy water comes up into
the shower basin (units with
side inlets)| • Shower installed too low as compared with the macerator unit
• Hinged side inlet discs clogged up| • Check the installation
• Clean the hinged discs
• Otherwise, ask an approved repair agent to intervene
GUARANTEE
2 years guarantee as from its date of purchase subject to correct installation
and correct use.
Only the disposal of toilet paper, faecal matter, and waste water will be
under guarantee. Any damage due to foreign bodies such as cotton, condoms,
sanitary towels, wet wipes, food, hair, metal, wood or plastic objects, will
not be under guarantee. Solvents, acids and other chemicals can also cause
damage to the unit, and will invalidate the guarantee.
SANIFLO Ltd.,
Howard House, The Runway
South Ruislip Middx.,
HA4 6SE
Tel. +44 208 842 0033
Fax +44 208 842 1671
SERVICE HELPLINES
United Kingdom
08457 650011 (Call from a land line)
020 8842 1671
References
- ëŒ€í•œë¯¼êµ ì •ì±…ë¸Œë¦¬í•‘
- saniflo.co.za
- SFA Sanitrit
- Welcome on SFA BIZ
- SFA | Fabricant français de pompes à eau et broyeurs wc
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>