EJEAS Q2 Motorcycle Intercom System User Manual

June 9, 2024
EJEAS

Q2 Motorcycle Intercom System
User ManualEJEAS Q2 Motorcycle Intercom System

Product Details

EJEAS Q2 Motorcycle Intercom System - Figure 1

Product installation

EJEAS Q2 Motorcycle Intercom System - Figure 2

Product Operations

Operation Diagram

EJEAS Q2 Motorcycle Intercom System - Figure 3

Power ON/OFF Please Chage it before using.

ON Prompt tone
Standby Blue light flashes slowly EJEAS Q2 Motorcycle Intercom System -
Figure 5

OFF
Press the and simultaneously.
Lights off

Battery Level

EJEAS Q2 Motorcycle Intercom System - Figure 6

“Battery Level High”
“Battery Level Medium”
“Battery Level Low”

Low Battery Indication

EJEAS Q2 Motorcycle Intercom System - Figure 7

Red light flashes twice
Low Battery” EJEAS Q2 Motorcycle Intercom System - Figure
8

Charging Constantly red
Full The red light out
Volume Control FM and intercom can be used at the same time.
Intercom / Calling / Music / FM

|
---|---

When Intercom & FM use simultaneously, FM volume control

|
---|---

Factory Reset

Long press the <Volume +>, <Volume ->, for 5s at the same time.
The red and blue lights quickly flash four times simultaneously
Restore Default Setting”

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to  provide reasonable protection against harmful interference in a residential installation. This equi pment generates uses and can radiate radio frequency energy and, if not  installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does caus harmful interference to radio or television reception, which can be determined by turning the equipment off and  on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help

Changes or modifications not expressly approved by the party responsible for compliancecould void the user’s authority to operate the equipment. This device complies with  Part15 of the FCC Rules. Operation is subject to the following two conditions:

  1. this device may not cause harmful interference, and
  2. this device must accept any interference received, including interference that may cause undesired operation

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals