Livex Lighting 46503 Catania 3-Light Black with Brushed Nickel Accents Transitional Clear Instruction Manual
- June 8, 2024
- Livex Lighting
Table of Contents
Livex Lighting 46503 Catania 3-Light Black with Brushed Nickel Accents Transitional Clear
INTRODUCTION
- WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
- ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.
ASSEMBLING THE FIXTURE (Fig.1)
-
Shut off the power at the circuit breaker box. Remove old fixture and all hardware from Junction Box.
-
Carefully unpack your new fixture and lay out all the parts on a clear area.
Take care not to lose any small parts necessary for installation. -
End of pipe nipple screw(C) into single bar (D), place lock washer (B) over end of nipple protruding through single bar and lock it securely with the hex nut (A). Take this single bar assembly to junction box with junction box screws (E), tighten screws securely with screwdriver. The side of the single bar marked “GND” must face to out. The junction box is not included.
-
Holding the end cord of lamp holder(H), through the canopy’s column shape coupling, by measuring, determine correct cord length of needed for proper hanging height, then lock it securely with the small screw. NOTE: SLIDE WIRE CLIP TO THE PROPER POSITION, THEN YOU MAY PROPERLY CUT THE CORD IS TOO LONG PARTS. CONNECT THE ELECTRICAL WIRES AS SHOWN IN FIG.2.
-
While holding the lamp body towards the ceiling, connect the electrical wires as Shown in Fig.2, making sure that all wire nuts are secured. You may have to wrap the connections with electrical tape. If your outlet has a ground wire (green or bare copper), connect the fixture ground wire to it. Otherwise connect fixture’s ground wire directly to the single bar with the green screw provided. This lamp body provided two copper ground wires, one copper ground wire connects cord’s ground wire, other one copper ground wire connects outlet’s ground wire or mounting plate’s green screw. After wires are connected, tuck them carefully inside the Junction Box.
-
Raise the lamp body onto the junction box, aligning screw on single bar with mounting hole in canopy and lock it securely with the ball nut(G). Raise the glass(I) to the lamp holder(H), lock it securely with the check ring(J).
-
Install the light bulbs(Not included) in accordance with the fixture’s specifications. NOTE: DO NOT EXCEED THE SPECIFIED WATTAG!
Your installation is now complete. Return power to the junction box the fixture.
Customer Support
Thank you for purchasing a LIVEX product.
Need assistance with parts or assembly? Please call customer service
at:800-761-8056
Or visit us on-line
at:WWW.LIVEXLIGHTING.COM
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>