LIVEX LIGHTING 48974 Accents Sphere Linear Chandelier Instruction Manual
- June 8, 2024
- Livex Lighting
Table of Contents
LIVEX LIGHTING 48974 Accents Sphere Linear Chandelier
ASSEMBLING & INSTALLATION INSTRUCTIONS
- The drawing shown may not exactly match the product enclosed.
- However, the installation instructions do apply to this product.
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.
ASSEMBLING THE FIXTURE
- Shut off the power at the circuit breaker box. Remove old fixture and all hardware from Junction Box. Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to lose any small parts necessary for installation.
- By measuring, determine correct distance hole in mounting plate, then drilled four holes(by measuring distance hole) in the ceiling at junction box of side; raise the plastic anchor insert the hole. Attach the mounting plate to the junction box with two junction box screws and four wood screws as shown, tighten screws securely with the screwdriver. The side of the mounting plate marked “GND” must face out. The junction box is not included.
- Holding the end cord of shade, through the canopy’s cone shape coupling, by measuring, determine correct cord length of needed for proper hanging height, then lock it securely with the small screw. NOTE: SLIDE WIRE CLIP TO THE PROPER POSITION, THEN YOU MAY PROPERLY CUT THE CORD IS TOO LONG PARTS. CONNECT THE ELECTRICAL WIRES AS SHOWN IN FIG.2.
- While holding the lamp body towards the ceiling, connect the electrical wires as Shown in Fig.2, making sure that all wire nuts are secured. You may have to wrap the connections with electrical tape. If your outlet has a ground wire (green or bare copper), connect the fixture ground wire to it. Otherwise connect fixture’s ground wire directly to the Mounting plate with the green screw provided. This lamp body provided two copper ground wires, one copper ground wire connects cord’s ground wire, other one copper ground wire connects outlet’s ground wire or mounting plate’s green screw. After wires are connected, tuck them carefully inside the Junction Box.
- Raise the lamp body onto the junction box, aligning the canopy mounting holes with screw hole of the mounting plate in side, then lock it securely with the mounting screws. Raise the glass(B) to the lamp holder(A), lock it securely with the check ring(C).
- Install the light bulbs(Not included) in accordance with the fixture’s specifications.
NOTE: DO NOT EXCEED THE SPECIFIED WATTAG
Your installation is now complete. Return power to the junction box and test the fixture.
Thank you for purchasing a LIVEX product. Need assistance with parts or assembly? Please call customer service at: 800-761-8056 Or visit us online at: WWW.LIVEXLIGHTING.COM
©COPYRIGHT ALL RIGHTS RESERVED.LIVEX LIGHTING,INC. DOC20210448974
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>