LIVEX LIGHTING 48828-01 Uptown 8-Light Antique Brass Mid-Century Chandelier Instruction Manual
- June 8, 2024
- Livex Lighting
Table of Contents
LIVEX LIGHTING 48828-01 Uptown 8-Light Antique Brass Mid-Century Chandelier
Instruction Manual
ASSEMBLING & INSTALLATION INSTRUCTIONS
The drawing shown may not exactly match the product enclosed.
However, the installation instructions do apply to this product.
- WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
- ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.
ASSEMBLING THE FIXTURE (Fig.1)
-
Shut off the power at the circuit breaker box. Remove old fixture and all hardware from Junction Box.
-
Carefully unpack your new fixture and lay out all the parts on a clear area.
Take care not to lose any small parts necessary for installation. -
Raise the end of pipe thread into coupling, lock it with the hex nut until tight.
Raise the other end of pipe thread into single bar (D), place lock washer over the end of thread protruding through single bar and lock it securely with the hex nut. -
Slide the electrical wires through the tube(M)/(L)/(K)/(J)/(I)/(G)/ring(H)/ canopy(F) and assembled single bar(D).
By measuring, determine correct tube length needed for proper hanging height. -
Raise the tube(M) to the center pipe thread of the lamp body(N), raise the other tubes and assembled single bar(D) to the screw pipe nipple in order, then by turning it clockwise until tight.
-
While holding the assembled single bar(D) of fixture body to the ceiling junction box with junction box screws (E) as shown, tighten screws securely with screwdriver.
The side of the single bar marked “GND” must face out.
The junction box is not included. -
Connect the electrical wires as Shown in Fig.2, making sure that all wire nuts are secured. You may have to wrap the connections with electrical tape.
If your outlet has a ground wire (green or bare copper), connect the fixture ground wire to it.
Otherwise connect fixture’s ground wire directly to the single bar with the green screw provided.
After wires are connected, tuck them carefully inside the Junction Box.
-
Slide the canopy(F) onto the Junction box, lock it securely with the ring(H) until tight.
-
Install the light bulbs(Not included) in accordance with the fixture specifications.
NOTE: DO NOT EXCEED THE SPECIFIED WATTAGE! -
Raise the end screw of the crystal stick(A) insert to the top screw hole of the lamp body(N), by turn it clockwise until tight. Raise the end screw of the crystal stick(B) insert to the bottom adjacent screw hole of the crystal stick(A), by turn it clockwise until tight. Assembled using the same method the others crystal sticks(order: A, B, A, B, A……). Note: the crystal stick(C) only one,
you must mounted to the bottom center screw of the lamp body(N).
Your installation is now complete.
Return power to the junction box and test the fixture.
CUSTOMER SUPPORT
Thank you for purchasing a LIVEX product.
Need assistance with parts or assembly? Please call customer service at:
800-761-8056
Or visit us online at:
WWW.LIVEXLIGHTING.COM