Livex Lighting 49087 8 Inch Brushed Nickel Semi-Flush Ceiling Light Instruction Manual
- June 8, 2024
- Livex Lighting
Table of Contents
Livex Lighting 49087 8 Inch Brushed Nickel Semi-Flush Ceiling Light
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR
ASSEMBLING THE FIXTURE
- Shut off the power at the circuit breaker box. Remove old fixture and all hardware from Junction Box.
- Carefully unpack your new fixture and lay out all the parts on a clear area. Be care not to lose any small parts necessary for installation.
- Attach the crossbar to the Junction Box with the two junction box screws as shown. The side of the cross bar marked “GND” must face out. The junction box is not included.
- While holding the lamp body(A) towards the ceiling, connect the electrical wires as Shown in Fig.2, making sure that all wire nuts are secured. You may have to wrap the connections with electrical tape. If your outlet has a ground wire (green or bare copper), connect the fixture ground wire to it. Otherwise connect fixture’s ground wire directly to the crossbar with the green screw provided. After wires are connected, tuck them carefully inside the Junction Box.
- Install the lamp body’s canopy onto the junction box, aligning screw hole on cross bar with mounting holes in canopy, lock it securely with the screws (B).
- Install the light bulb(not included) in accordance with the fixture’s specifications.
NOTE: DO NOT EXCEED THE SPECIFIED WATTAGE!
Thank you for purchasing a LIVEX product.
Need assistance with parts or assembly? Please call customer service at:
800-761-8056
Or visit us online at:
WWW.LIVEXLIGHTING.COM
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>