DELTA FLY24-MB-R FLYNN Tilt Mirror Instructions
- June 8, 2024
- Delta
Table of Contents
DELTA FLY24-MB-R FLYNN Tilt Mirror
WHAT’S
INCLUDED
CARE INTRUCTIONS
Care should be given to the cleaning of this product. Although its finish is extremely durable, it can be damaged by harsh abrasives or polish. To clean, simply wipe gently with a damp cloth and blot dry with a soft towel.
BEFORE YOU BEGIN
-
Identify the four hole locations on template for your item. (2) Place tape on all four corners of the template. (3) Position template on wall in desired location making sure that it is level, then tape to the wall. (4) Mark hole locations and check to make sure marks are on wall. Remove template from wall.
- For ease of installation, READ through ALL instructions before you begin.
-
Use Phillips head screwdriver to fasten anchor (C) into drywall. NOTE: Some force may be needed to push anchor tip into drywall. (2) Turn/rotate anchor clockwise into wall until the top of the anchor is flat against wall.
-
Place the mounting bracket (A) (facing outward) on the wall. (2) Insert screws into bracket slots and anchors. (3) Turn and rotate screws (B) through bracket into anchors clockwise. Repeat for remaining bracket and screws.
NOTE: Slots in bracket allow for adjustment.
-
Use Allen wrench to loosen set screw in both posts.
-
Place one post over the mounting bracket with the set screw facing downward. The post must hook over the mounting bracket. ( 2) Use Allen wrench to hand tighten set screw
-
Assemble product (as shown) The post must hook over the mounting bracket. Place remaining post over the mounting bracket with the set screw facing down-ward. (2) Use Allen wrench to hand tighten set screw.
WARNING!
This item is not designed for use as a grab bar. Do not mount in locations
where product is likely to be used as a grab bar.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>