AURA UNDERBODY with Unlock and Door Assis / 8PC Installation Guide
- June 9, 2024
- Aura
Table of Contents
UNDERBODY
WITH UNLOCK & DOOR ASSIST /8PC
INSTALLATION GUIDE
OPT7
MAIN COMPONENTS
INSTALLATION
STEP 1
Decide where to locate the control box and ensure wiring has enough length for
light bars to be installed in desired location.
IMPORTANT:
The control box must be installed inside the vehicle as it is not waterproof.
Avoid installation areas of the engine bay + heated surfaces.
As shown below, connect all the LED bars to the control box with the included
extension cables.
IMPORTANT:
The extension wires are on the led bar. Lay out the bars to measure the length
prior to install for a successful installation.| 4 × 24″ LED Bar + 8ft
extension wire
2 × 18″ LED Bar + 18ft extension wire
2 × 18″ LED Bar + 8ft extension wire
---|---
HOW TO CONNECT POWER HARNESS TO YOUR VEHICLE
- Connect the Red line(+) of power hareness to the vehicle battery’s positive terminal.
- Connect the Black line (-) of power hareness to the vehicle battery’s negativeterminal or an unpainted area on your vehicle’s frame.
WARNING
- Connecting to more than 10 AMP will override the kit and cause early failure, ensure it is 10AMPs or less!!
- Please ensure that the LED bars or strips/control box/wiring all are mounted in areas where will not exceed 85 or 185.
STEP 2
Secure Control box in desired location with Velcro or zipties.
- CONTROL BOX NOT WATERPROOF Ensure the control box is safely and securely hidden from exposing elements of moisture.
STEP 3
Secure the light bars using the zip ties to tie all the wiring away from the
moving components.
- IMPORTANT: The LED connectors are not waterproof. You will need to use HEAT SHRINK TUBE (not included) or ELECTRICAL TAPE around the LED connectors to ensure the longevity of the lighting kit.
STEP 4
Using the included E-Z Remote, select your desired color or pattern.
AUX WIRING FOR A DOOR/DOME LIGHT
http://qr.w69b.com/g/pa9DknB6g
Please scan to see a detail instruction on Door Assist Sync or go to https://wintis.ladesk.com/549690-AURA-Door-AssistAUX-Installation-Guide
CONTROL WIRE FOR A DOOR UNLOCK LIGHT
Please make sure the control wire (wire with the yellow sticker) is connected
to an “ACC/On” power source; otherwise, when unlocking it with the car
keyfob, it will not trigger any light effects!!
NOTE: When remote unlock feedback is enabled, it will glow blue for 15
seconds.
DISCLAIMER
OPT7 Lighting is not liable for damages or personal injuries while installing
this product. The Installation Guide is intended as assistance to reduce setup
time. OPT7 Lighting assumes no responsibility for improper installation. If
you are unfamiliar with your vehicle or inexperienced with aftermarket
upgrades, please seek professional assistance.
OPT7 recommends installation for safety and guidance.
Modified installations or installation recommendations not specified by OPT7
Lighting will void product warranty.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>