VIVOTEK FT9361-R Facial Recognition Tablet Installation Guide
- June 4, 2024
- Vivotek
Table of Contents
VIVOTEK FT9361-R Facial Recognition Tablet
Physical Description
No. | Description | No. | Description |
---|---|---|---|
2 | Lens | 8 | Display |
3 | Flash light | 10 | NFC induction zone |
4 | TOF lens | 11 | Retention screw |
5 | Light sensor | 12 | Reset button |
6 | Infrared lens | 13 | Cables |
7 | – | 14 | Tamper key |
Installation
Bracket Moumnt
The mount bracket will be available later.
- Secure the back plate to the mount bracket using 4 M3 x 8.0mm screws.
- Route cables through a hole on the wall or through the bracket. Below are the definitions for these cables.
Lines| Name| Color| Description
---|---|---|---
Line1| GND| Black| GND
12V| Red| 12V input
GND| Brown| GND
12V| White| 12V input
WG_DO| Purple| Wiegand/output DO
GND| Blue| GND
WG_DI| Green| Wiegand/output DO
DC12V_OUT| Orange| 12V output
Line2| Button_HC32| Black| Button for gate open
Senses_HC32| Red| Senses for gate open
Alarm_In_HC32| Brown| Alarm input
GND| White| GND
RS485_A| Purple| RS485 A
RS485_B| Blue| RS485 B
NC| NC| No connection
NC| NC| No connection
Relay_SW3_B| Green| Relay3 B
Relay_SW3_A| Orange| Relay3 A
Line3| NC| NC| No connection
Relay_SW2_B| Black| Relay2 B
Relay_SW2_A| Red| Relay2 A
NC| NC| No connection
Relay_SW1_B| Brown| Relay1 B
Relay_SW1_A| White| Relay1 A
NC| NC| No connection
Relay_Lock_NO| Purple| Relay normally open
Relay_Lock_COM| Blue| Relay normally grand
Relay_Lock_NC| Green| Relay normally close
GND| Orange| GND
NC| NC| No connection
Line4| RJ45| –| RJ45 Ethernet - Mount the sensor device onto the bracket by sliding it from top down.
Login and Registration
Server Configuration
- Network configuration: When the FT9361-R is started, proceed with network configuration. DHCP or Static IPs are applicable.
- Server: The FT9361-R requires a connection to a VAST Face Manager server. Click on the Configuration button on the upper right of screen to configure a VAST Face Manager server IP.
- Changing Server IP: If you need to change server IP, you need to logout and click the Settings button on the upper right corner of the screen.
Log in to the account
Login: On the first startup, credentials are required for a name and password.
Registration
- Equipment Registration: Register the name of the device and the installation site.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>