FREEDOM 73040719 Louvered Gate Kit Instruction Manual

FREEDOM 73040719 Louvered Gate Kit Instruction Manual

freedomproduct.com

⚠ WARNING:

• Improper installation of this product can result in personal injury. Always wear safety goggles when cutting, drilling and assembling the product.
• Incorrect installation may cause harm to the gate or individual.
• Check local building codes to determine pool-safe fencing options.
• Do not allow children to play with the gate.

NOTICE:

• DO NOT attempt to assemble the kit if parts are missing or damaged.
• DO NOT return the product to the store, for assistance or replacement parts call: 1-888-418-4400.

BEFORE YOU BEGIN:

Vinyl gate posts require an internal support system for weight-bearing purposes therefore a post stiffener is required. Post stiffener needs to be purchased separately.

TOOLS/MATERIALS NEEDED:

Component list:

To obtain and review a copy of the warranty please visit freedomproduct.com/warranty. You may also contact us at 1-888-418-4400 or email freedom@barretteoutdoorliving.com. 2

1. a. Apply provided vinyl cement to all inside surfaces of the uprights where the rails will be Vinyl Cement installed (Fig. 1).
   b. Install top and bottom rails into one gate upright (Fig. 2).

2. Install all infill boards into gate upright with rails (Fig. 3).

3. Install final upright insuring that infill boards and rails line up with routes (Fig. 4).

4. Ensure gate is square. Measure diagonally from top of left corner rail (A) to bottom of right corner Fig. 5 rail (B) and note the length. Then, measure diagonally from top of right corner rail (C) to bottom of left corner rail (D). Note the length. Make sure both measurements are the same before installing screws into uprights (Fig. 5).

5. Install two 6″ screws (provided) through each upright insert and into the rail using the Molded grooves on the insert as a guide (Fig. 6).

6. Install upright caps onto the top of each upright with remaining vinyl cement (Fig. 8).

7. Attaching Barrette Outdoor Living Hinge To The Upright:
   a. Attaching the hinges to the inside of the gate will allow the gate to open inward. When attaching them to the outside, the gate will swing outward.
   b. Mark and pre-drill 3/32″ pilot holes on top and bottom upright. Secure using six 11/2″ screws (provided with the hinge) to front and side of the upright (Fig. 9). Repeat for the bottom hinge.

8. Hold the gate level to the post, pre-drill holes with 3/32″ bit and secure with six 11/2″ screws to the post (Fig. 10). Repeat for the bottom hinge.

NOTE: Use 2″ blocks to align the gate with the fence and help hold the gate steady (Fig. 11).

Barrette Outdoor Living 7830 Freeway Circle, Middleburg Heights, OH 44130
freedomproduct.com · 888-418-4400

References

• Barrette Outdoor Living: HomePage
• Fencing, Railing & Accents - Freedom Outdoor Living for Lowes
• freedomproduct.com/warranty

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>