FREEDOM 73050520 2.5-in x 2.5-in x 6-ft Matte Black Aluminum Deck Post Instruction Manual
- October 28, 2023
- FREEDOM
Table of Contents
Post Extension
For Aluminum Rail
INSTALLATION INSTRUCTIONS
WEB REV 6.22
73050520 2.5-in x 2.5-in x 6-ft Matte Black Aluminum Deck Post
Read all instructions prior to installing product.
Refer to manufacturers safety instructions when operating any tools.
To register your product, please visit:
freedomproduct.com
WARNING:
- Improper installation of this product can result in personal injury. Always wear safety goggles when cutting, drilling and assembling the product.
- Post extension is designed for use with Barrette Outdoor Living® Standard duty Aluminum Railing posts.
- Not for load-bearing use.
NOTICE:
- DO NOT attempt to assemble the kit if parts are missing or damaged.
- DO NOT return the product to the store, for assistance or replacement parts call: 1-888-418-4400.
Component List:
| QTY | Description |
|---|---|
| 1 | 65″ post extension |
| 1 | Post Coupler |
| 2 | J Hooks |
| 10 | #10×1″ screws |
TOOLS/MATERIALS NEEDED:
| Safety Goggles
---|---
| Tape Measure
| Power Screwdriver/drill
| 5 ⁄ 5 32 ” drill bit
To obtain and review a copy of the warranty please visit
Freedomproduct.com/warranty.
You may also contact us at 1-888-418-4400 or email
[email protected].
-
Determine the desired finished height of your post. The post extension is 65″ long. Cut the post extension to the desired height.
-
Remove the post cap from the installed post. Attach the post cap to the end of the extension.
-
Attach the “J” hooks at the top of the post extension near the post cap.
a. Mark the holes and pre-drill with a 5 ⁄32 ” drill bit and secure with provided #10 x1″ long screws. (Fig 1). -
Insert coupler into the bottom of the extension. Tap with a rubber mallet until firmly seated.
-
Using the pre-drilled holes as a guide secure the coupler to the extension by pre-drilling the 4 holes with a 5 ⁄ 32 ” drill bit and secure with four #10 x 1″ screws (Fig 2).
a. Attach the post extension by firmly seating the coupler into the top of the installed post. Make sure the “J” hooks that were installed earlier are in the correct orientation. Tap top of extension with a rubber mallet to firmly seat.
b. Using the pre-drilled holes as a guide, secure the coupler to the extension by predrilling the 4 holes with a 5 ⁄32 ” drill bit and secure with four #10 x 1″ screws (Fig 3).
Barrette Outdoor Living
7830 Freeway Circle, Middleburg Heights, OH 44130
freedomproduct.com
(888) 418-4400
REV 6.22
References
- Barrette Outdoor Living: HomePage
- Fencing, Railing & Accents - Freedom Outdoor Living for Lowes
- Freedomproduct.com/warranty