HYUNDAI 58600 Slang-Wandcassette Instruction Manual
- June 2, 2024
- HYUNDAI
Table of Contents
HYUNDAI 58600 Slang-Wandcassette Instruction Manual
RETRACTABLE HOSE REEL 58600
WARNING
Read all safety warnings and all instructions. Failure to follow the warnings
and instructions may result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
The following symbols are used throughout this manual:
⚠ Denotes risk of personal injury or damage to the machine.
Denotes important information concerning the use of the machine.
⚠ Not intended for use by children.
DESCRIPTION (FIG. A)
- Wall mounting bracket
- Bar
- Nozzle
- Plugs and screws
MOUNTING (FIG. B-D)
The bracket can be mounted on other secure structures, but fixings included are only suitable for masonry anchoring.
-
Choose a suitable position on a wall.
-
Mark the drill holes.
-
Drill 4 holes of the correct diameter for the plugs.
-
Insert the plugs into the drilled holes.
-
Screw on the wall bracket.
⚠ Fix the wall bracket upwards. -
Align the hose reel with the vertical holes in the bracket and insert the pivot bar through the bracket and reel.
-
Attach the short connecting hose from the hose reel body to the water tap. Once you turn on your tap, the water will flow through this hose, through the hose reel to the spray nozzle.
-
By twisting the end of the spray nozzle the water flow can be regulated.
USE
This hose reel system has been equipped with a click-lock mechanism.
- Pull the hose out to the desired length. When you stop pulling, the hose will automatically
⚠ Turn off the water flow before retracting the hose.
- To engage the automatic hose recoil, give it a short sharp pull.
- Pull the hose again to interrupt retracting.
⚠ Guide the hose while retracting. Letting go of the hose can cause injury.
MAINTENANCE
- Always keep the hose clean after use.
- Store the hose reel cassette in an enclosed space in winter.
TECHNICAL DATA
Hose length m 20
Hose material PVC
Max. pressure bar 24
Inner diameter hose mm 8
Female thread fitting (BSP) ” 3/4
ENVIRONMENT
Your product, accessories and packaging should be sorted for environmental
friendly recycling.
Subject to change; specifications can be changed without further notice.
GUARANTEE
This product has been thoroughly checked in the factory. After purchase date a
full 2 year’s guarantee applies to material and production defects. The
receipt s also the guarantee card and must be submitted in case of claim to
guarantee. In case of possible problems within the period of guarantee, you
must contact your purchase address.
Guarantee conditions
If the product shows defects as a result of material and production defects
during the period of guarantee, we guarantee free repair on condition that:
– The produt has been used properly and for the purpose for which it has been
intended.
– Repairs are professionally carried out by a person appointed by the
supplier.
– The proof of purchase will be submitted.
If, during the period of guarantee, a defect emerges that cannot be repaired,
free replacement of the product takes place.
Service
After the period of guarantee, should repairs be required we will pay the
greatest possible attention to repair the tool.
For service and/or repair outside the period of guarantee, you can directly
contact the address below:
Dvize bv PO Box 150 1910 AD Uitgeest The Netherlands
[email protected]
www.hyundaipowerproducts.nl
Dvize bv
PO Box 150
1910 AD Uitgeest
The Netherlands
[email protected]
www.hyundaipowerproducts.nl
Imported/Distributed by Dvize bv, The Netherlands Licensed by Hyundai Corporation Holdings, Korea